Maintenance And Storage Of Saw - Remington RM0815P Manual Del Usario

IMportaNt SaFEtY INForMatIoN
• For chain saw, use firm grip. Thumbs and
fingers must wrap around saw handles.
• For pole saw, have one hand gripping the
handle and the other gripping the pole. Use
firm grip. Thumbs and fingers must wrap
around pole and handle.
• Use both hands to grip saw while saw is
running. Use firm grip. Thumbs and fingers
must wrap around saw handles.
• Keep all safety items in place on saw. Make
sure they work properly.
• Chain saw - do not overreach or cut above
shoulder height.
• Pole saw - do not overreach or extend arms
above shoulder height.
• Keep solid footing and balance at all
times.
• Stand slightly to left side of saw. This keeps
your body from being in direct line with
chain.
• Do not let guide bar nose touch anything
when chain is moving (see Figure 1).
• Never try cutting through two branches at
same time. Only cut one log at a time.
• Do not bury guide bar nose or try plunge cut
(boring into wood using guide bar nose).
• Watch for shifting of wood or other forces
that may pinch chain.
• Use extreme caution when reentering a previous
cut.
• Use low-kickback chain and guide bar sup-
plied with this chain saw. Only replace these
parts with chains and guide bars listed in this
manual.
• Never use dull or loose chain. Keep chain
sharp with proper tension.
Saw Maintenance and Kickback
Safety
Follow maintenance instructions in this manual.
Proper cleaning of saw and chain and guide bar
maintenance can reduce chances of kickback.
Inspect and maintain saw after each use. This will
increase the service life of your saw.
Note: Even with proper sharpening, risk of kick-
back can increase with each sharpening.
Direction
Do Not Let
Guide Bar
Touch Here
90°
Figure 1 - Kickback Hazard Example: Do Not
Let Nose of Guide Bar Touch Object While
Chain is Moving
MaINtENaNcE aND StoraGE oF
Saw
1. Unplug saw from power source:
• when not in use
• before moving from one place to an
other
• before servicing
• before changing accessories or attachments,
such as saw chain and guard
2. Inspect saw before and after each use. Check
saw closely if guard or other part has been dam-
aged. Check for any damage that may affect
operator safety or operation of saw. Check for
alignment or binding of moving parts. Check
for broken or damaged parts. Do not use saw
if damage affects safety or operation. Have
damage repaired by authorized service center.
3. Maintain saw with care:
• Never expose saw to rain.
• Keep chain sharp, clean, and lubricated
for better and safer performance.
• Follow steps outlined in this manual to
sharpen chain.
• Keep handles dry, clean, and free of oil
and grease.
• Keep all screws and nuts tight.
• Inspect power cord often. If damaged,
have repaired by authorized service cen
ter.
• Never carry saw by power cord.
• Never yank power cord to unplug it.
• Keep power cord from heat, oil, and sharp
edges.
• Inspect extension cords often and re
place if damaged.
4. When servicing, use only identical replace-
ment parts.
5. When not in use, always store saw:
• in a high or locked place, out of children's
reach
• in a dry place
• in a carrying case or with scabbard over guide
bar
• drain oil after each use and before storing saw
to prevent oil leakage.
Save these instructions. It is your guide to safe
and proper operation of this saw.