Idiomas disponibles
Idiomas disponibles
1.3 - INSTALLATION OF THE APPLIANCE
•
After removing the packaging, check that the appliance is in perfect condition; in case of doubts do not use it and
refer to professionally qualified personnel.
• Install the appliance on a rigid and levelled floor while keeping the room ventilated.
•
Place the appliance in a suitable environment.
Make sure that curtains or other objects don-t obstruct the air flow (Fig. 5).
•
Leave at least 20cm of free space on both sides and behind the appliance and leave at least 30cm of free space
above it (Fig. 1).
•
Remove the tank (7) and uncoil the supply cord (9).
•
Correctly reposition the tank (7) in the appliance body.
•
Insert the plug in the power socket; the appliance emits a "beep" and the display shows the percentage of hu-
midity in the room.
1.4 - CONTROL PANEL
21
STAND BY key (ON/
OFF)
Press this key to start/
switch off the appli-
ance.
22
DOWN key
Press this key to lower
the settable value or to
scroll back the selecta-
ble modes.
23
UP key
Press this key to in-
crease the settable
value or to scroll for-
wards the selectable
modes.
24
TIMER key
Press this key to enter the appliance start/switch off programmation mode.
25
"Timer" led
This led switches on in green when the timer function is active.
26
"Defrosting" led
This led switches on in green when the defrosting function is active.
27
"Compressor status" led
This led switches on in green when the compressor is active.
28
"Water tank full" led
This led switches on in red when the water tank is full; the appliance emits a "beep" and switches
off.
EN - 17
25
26
29
24
23
27
28
22
21
Capítulos
