Turning On Power And Charging The Battery; Power Save Mode; About The Mac Address - SonoSite SonoRemote Control Guia Del Usuario

• Blinking fast Remote control is trying to
establish a connection by Bluetooth
technology.
• Blinking slowly Remote control is searching
for Bluetooth devices.
USB indicator
• Solid Remote control is connected by USB
cable.
Turning on power and charging the
battery
Before using the remote control, make sure that
the battery is charged.
You can charge one remote control while using
another that is connected by Bluetooth
technology.
To turn the remote control on or off
Press the power switch
See Figure 1 and Figure
To charge the battery
1 Connect the ultrasound system to AC power.
2 Turn on the ultrasound system and remote
control.
3 Connect the remote control by USB cable. (See
"To connect by USB cable" on page 4.) Use a
USB port that is on the system, not on a dock.
Note: If you connect to a dock instead of to the
system and if the system enters power save mode,
the remote control does not charge.
The battery fully charges in less than three and a
half hours. If the remote control power is on, the
ultrasound system ignores the sleep and power
delay settings for three hours, allowing the
battery to charge.
If the system enters power save mode, the battery
continues to charge. If the system turns off, the
battery does not charge.
.
2 on page 2.

Power save mode

The remote control beeps three warning beeps
and enters power save mode after the following
period of inactivity:
• (Microphone connected) 15 minutes without a
voice command
• (Microphone disconnected) 5 minutes
without a button press
All indicators but the power indicator turn off.
After 30 minutes in power save mode, the remote
control turns off.
To wake from power save mode
Press a button, or say a voice command.

About the MAC address

The remote control's Media Access Control
(MAC) address appears in the ultrasound
system's Bluetooth Devices list and helps you
confirm that the correct Bluetooth device is
connected.
Find the MAC address and apply the label to the
remote control to ensure that this unique
identification information is readily available.
To find the MAC address and apply the label
1 Remove a MAC address label from its
protective backing.
2 Adhere the label to the back of the remote
control, in the rectangle at the bottom.
3 Find the MAC address: Connect by Bluetooth
technology. (See "To connect by Bluetooth
technology" on page 4.) The MAC address,
BlueHID ##:## (where ##:## are four unique
numbers or letters), appears in the Bluetooth
Devices list.
4 Using a permanent marker, write the MAC
address on the label.
3