Alpine PWD-X5 El Manual Del Propietario página 15

Connection Diagram Details
1 Main machine USB port connects to the
computer via USB3.0 cord. Start PWD-X5
software to switch sound sources of main
machine and perform such functions as data
storage, calling and EQ. USB port connects
to the wired controller via USB3.0 cord and
perform functions including switching sound
source, data calling and adjusting master
volume via the wired controller.
2 The main machine is equipped with an external
Bluetooth interface to play lossless music via
the external digital Bluetooth and connect to
PWD-X5 app. After the Bluetooth is connected,
the indicator light will be on.
3 AUX input interface connects to in-vehicle CD
or DVD low-level output, switches the machine
sound source to AUX input and plays low-level
signals.
4 REM input switch. When the switch is placed
on the "REM"-end, REM will start the machine.
If the switch is placed on the "DC"- end, the
high-level input signal will start the machine.
5 In-vehicle CD or DVD main machine.
6 High-level input and power input interface
connects to in-vehicle CD or DVD. If the sound
source switches to high-level, the machine will
play high-level signals.
POWER INPUT
REM
BATT BATT BATT RR+
IN
GND GND GND RR-
7 The amplifier output of the main machine
connects to the speaker.
8 The machine is connected to the power supply.
Notes:
● Original cables for designated vehicles only.
● High-level REM input (HOST): for these two
high-level input cables of H1+/H3+.
HIGH INPUT OUTPUT
RL+ FR+ FL+ FL+ FR+
RL- FR- FL- FL- FR-
FCC information:
Changes or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate the equipment.
This device complies with Part 15 of FCC Rules
and Industry Canada license-exempt RSS
standard(s). Operation is subject to the following
two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of this device.
Le présent appareil est conforme aux la partie
15 des règles de la FCC et CNR d'Industrie
Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux
conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre
le fonctionnement.
IC Information:
This device complies with Industry Canada licence-
exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) this device may not cause interference
(2) this device must accept any interference,
RL+ RR+
including interference that may cause undesired
RL- RR-
operation of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables auxappareils radio
exempts de licence.
L'exploitation est autorisée aux deux conditions
suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout
brouillage
radioélectrique subi, même si le brouillage est
susceptible d'en compromettre lefonctionnement.
15