Kruger FTX13011PRO Instrucciones Para El Uso página 12

Congratulations! We wish to thank you
for buying this cleaner. You have shown that you do not accept compromises: you want the best.
We have prepared this manual to enable you to fully appreciate the qualities and high performance that this cleaner can
offer you.
Please read it completely before using the machine.
The CE mark on your cleaner shows that it has been constructed in compliance with the European Standards on safety.
We can also offer you a wide range of cleaning machines such as:
VACUUM CLEANERS, FLOOR CLEANERS, FLOOR SWEEPERS and a complete range of ACCESSORIES, CHEMICALS and
DETERGENTS suitable for cleaning all kinds of surfaces.
Ask your Dealer for the complete catalogue of our products.
The text has been carefully checked, however any misprints should be notified to the
The manufacturer also reserves the right to alter and update this publication without
All reproductions of this manual, in whole or in part, are forbidden without the manu-
PREPARING THE CLEANER
Fitting the lance (Fig. 1)
Fitting the lance (Fig. 2)
Water circuit connection (Fig. 3)
Electrical connection (Fig. 4)
Continue reading this manual without
connecting the cleaner to the power mains
and the water supply.
The most important instructions
are marked with the symbol:
INTRODUCTION
This manual must be read before installing, setting
up and using the cleaner. The manual is an integral
part of the product. It is composed of two parts, one
of which is yellow.
Read the warnings and instructions in this manual
carefully as they provide important indications as to
SAFETY IN USE and MAINTENANCE, paying
special attention to the general rules for safety listed
in the yellow booklet.
KEEP THIS MANUAL CAREFULLY FOR FUTURE
CONSULTATION.
The contents of this booklet must be brought to the
attention of persons using or carrying out routine
maintenance on this water cleaner.
manufacturer.
prior notice for the sake of product improvement.
facturer's authorization.
CLASSIFICATION
he user must observe the conditions of use of the
appliance prescribed by the Rules, and particularly he
must respect the following classification:
As for the protection against electric shock, the
H.P.cleaner belongs to CLASS I.
The H.P. cleaner is factory set and all its safety devices
are sealed. It is forbidden to alter their adju-
stment values.
The H.P. cleaner must be always used on a firm and
flat ground, furthermore it must not be moved while it
is working or connected to the electric supply.
The water cleaner is considered as a fixed device.
Failure to observe this prescription may cause danger
for the user.
The H.P. cleaner must not be used in the presence
of corrosive or potentially explosive atmospheres.
(vapours or gas)
The electric connection must be performed by qualified
technicians who are able to work in observance of the
governing rules (as far as Italy is concerned please refer to
the law 46/90) and of the manufacturer's instructions.
A wrong electric connection may cause damage to per-
sons, animals or things, and the manufacturer cannot
be considered responsible for these.The H.P. cleaners
with power lower than 3 kW are equipped with a plug
for connection to the electric supply.
In this case please check if the electric power system and
the electric sockets are compatible with the max. power
of the appliance indicated on the plate. (kW)
In case of doubt, please apply to qualified personnel.
If the socket and the plug of the machine are not com-
patible, have the plug replaced with a suitable type by
qualified personnel.
Before connecting the machine make sure that the
data indicated on the plate correspond to those of the
electric supply.
Do not use extensions to feed the H.P. cleaner.
12