Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Muffler
Engine exhaust
exits the engine via the muffler.
Fuel Cap
Unscrew the fuel cap to add gasoline
to the fuel tank. This unit
runs on regular gas.
Oil Fill Cap& Dipstick
Engine oil level can be checked and oil added through
the oil fill.
NOTE: This unit was shipped
WITHOUT
oil in the engine.
Oil
is included
in the plastic bag packed the manual in with the unit.
Add the oil as directed
in the Setup section.
Check the oil level
before each operation
to ensure adequate
oil is in the engine.
For
further
instructions,
refer to the steps in the Engine Maintenance
section
of this manual.
ReverseHandle
The Reverse Handle controls
the reverse drive of the wheels and
tines.
ForwardClutch Bail& TineEngagement
The forward
clutch bail controls
the engagement
of the forward
drive of the wheels and tines.
DepthRegulator Lever
This lever controls
the tilling
depth
of the tines. Pull the lever
back and slide it up or down to engage the notched
height
settings.
HandlebarHeightAdjustment
The handlebar height is adjustable to three different settings. In
general, adjust the handlebars so they are at waist level when the
tines are 3-4" in the ground.
RearTine Shield
The rear tine shield protects
the operator
from flying debris
while also smoothing
out freshly tilled
soil.
SideShield
The side shield is used to maintain
clear even rows and may be
adjusted
to one of five different
positions.
Tines
Your tiller's tines are a series of hoes arranged
on a revolving
power-driven
shaft.
WheelDrivePins
Each wheel is equipped
with a wheel drive click pin that secures
the wheel to the wheel shaft. The wheels can be positioned
in
either a WHEEL DRIVE or a FREEWHEEL mode.
Oil Drain
Removing
the oil drain plug will drain the oil from the engine.
SECTION
4 -- CONTROLS
AND FEATURES
11
Tabla de contenido
