Filling The Solution Tank; Pre-Spraying The Carpet; Plan For Cleaning - Nilfisk Advance AquaPLUS Instrucciones De Uso

FILLING THE SOLUTION TANK

Fill the solution tank with a maximum of 20 gallons (76 Liters) of cleaning solution. Do not fi ll the solution tank above 7.5 cm (3 inches) from the
bottom of the Solution Fill (1). Use the Solution Level Indicator (22) to monitor the solution level while fi lling. The solution should be a mixture of
water and the proper cleaning chemical for the job. Always follow the dilution instructions on the chemical container label. NOTE: AXP machines
can either be used conventionally with detergent mixed in the tank or the AXP detergent dispensing system can be used. When using the AXP
detergent dispensing do not mix detergent in the tank, plain water should be used. If the pump is not pumping water, there may be air in the
line and it may not be properly priming. This can be corrected by making sure the solution tank is fi lled at minimum to the 20 gallon
level to start out.
CAUTION!
Use low-sudsing, non-fl ammable liquid detergents designed for carpet extraction. Water temperature should not exceed 130
degrees Fahrenheit (54.4 degrees Celsius).
BEFORE USING THE AQUAPLUS™
Thoroughly vacuum the carpet to be cleaned before using the AquaPLUS/AquaPLUS AXP automatic carpet extractor.

PRE-SPRAYING THE CARPET

The AquaPLUS AXP model has a pre-spray feature. Pre-spray spots and heavy traffi c areas before extracting. For extremely dirty fl oors, a
one-pass scrubbing operation may not be satisfactory and a "pre-spray" operation may be required. This operation is the same as a one-pass
scrubbing except on the fi rst pass the vacuum shoes are in the up position and the vacuum motors are off. This allows the cleaning solution/
detergent to remain on the fl oor to work longer. The fi nal pass is made over the same area, with the vacuum shoes lowered and vacuum motors
on to pick up the accumulated solution.
1 The scrub system must be in the off position.
2 Press the Solution/Pre-Spray Switch (C), the Display (D7) will indicate Fast Prespray Mode. The scrub deck will be lowered and the solution
and detergent systems will be enabled. The Extraction Shoes (10) will remain in the up position.
3 Push the Drive Paddle (20) forward to start the brushes and solution/detergent.
4 Press the Scrub ON Switch (J) to enter the Heavy Prespray Mode, if more solution is desired. The Display (D8) will indicate the Heavy Prespray
Mode has been selected. In this mode the machine moves slower and more solution is sprayed on the carpet.
5 Press the Solution/Pre-Spray Switch (C) to exit the prespray mode. The brushes and solution/detergent fl ow will be stopped. The scrub deck
will raise.

PLAN FOR CLEANING

Before you begin extracting, look at the area to be cleaned and plan your work. Divide the space into sections. Overlap each pass 2 inches (5
cm).
revised 11/13
ENGLISH / A-11
AquaPLUS , AquaPLUS AXP
™
- 56041677 - A-11
™