Electrical Connections; Pneumatic Connections; Chapter 3. Machine Adjustment And Setting Up; Control Panel - Minipack-Torre Plexi 30 Instrucciones Para La Instalación, Uso Y Mantenimento

Chapter 2. Machine installation

2.3. Electrical connections

OBSERVE HEALTH AND SAFETY REGULATIONS!
If the machine is not equipped with the power supply plug, use a plug that is suitable for the
voltage and amperage values described by the rating plate and that can comply with the
rules in force in the installation country.
GROUNDING OF THE UNIT IS OBLIGATORY!
Before making electrical connections, make sure the mains voltage matches the one on the
plate on machine rear and that the ground contact complies with the safety rules in force.
In case of doubts about the mains voltage, contact the local power supply company.
Insert the plug on the cable from machine electrical cabinet in a mains power supply socket
that can be reached easily by the operator.

2.4. Pneumatic connections

Connect the compressed air connection 14 (figure 1.3 page 15) at the exit of the machine. Use a pipeline having a
minimum diameter of 6 mm. and a 1/4" female union.

Chapter 3. Machine adjustment and setting up

3.1. Control panel

1. Display FN. Displays "J" (Jog) if manual or maintenance operations have been carried out on the machine, or if the
reset manoeuvre has not been carried out yet. To carry out the reset manoeuvre, press the START button. Displays
"A" (Automatic) if the machine is ready for to operate.
2. Display REAR. Displays the quantity of file behind the product.
3. Display LENGTH. Displays the length of the envelope.
4. Display CROSS SEAL. Displays the cross sealing temperature (pliers).
5. Display PCS MIN. Displays the number of envolopes produced per minute
6. Display TOTAL-CENTER SEALING. Displays the total number of envelopes produced. To reset, press and hold
the button (19).
7. Emergency button. Stops the machine immediately in the event of imminent danger or when selecting
maintenance mode. To release this button, rotate it counter-clockwise.
8. RESET button. For alarms E5, E6, E7, E12, and E13.
9. Activate pushers button. When the machine is stationary, press this button and the START button simultaneously
tom ove the pushers forward.
10. A pliers button. Press this button and button 9 simultaneously to open and close the A pliers.
11. B pliers button. Press this button and button 9 simultaneously to open and close the B pliers.
12. START button. Starts the packaging cycle.
Press once to set the machine to the START position.
Press again to start the packing cycle.
13. "DECREASE" button. Reduces the pliers sealing pulse duration (see note No.1).
14. "INCREASE" button. Increases the pliers sealing pulse duration (see note No.1).
15. STOP button. Stops the packaging cycle.
16
EN
EN