Tabla de contenido
Idiomas disponibles
Idiomas disponibles
"UP" Position
• _...
Tighten handle
, '"'.. lock Iever to hold
Handle Column
/
/
/
/
Cables
Loosen Handle Lock
Lever to Move
4.
Insert pivot bolt in front part of plate
and tighten,
5,
Cut down remaining
corners of carton
and lay panels flat,
6- Lower the handle assembly.
Tighten
nut on carriage
bolt so handle moves
with some resistance.
This wilt allow
for easier adjustment,
7.
Place flat washer
on threaded
end of
handle lock lever,
8,
Insert handle lock lever through
handle
base and gearcase.
Screw in handle
lock lever just enough
to hold lever in
place,
9,
Insert second
handle
lock (with teeth
inward)
in the slot of the handle base
(just inside of washer),
10_ Raise
handle assembly
to highest
position
and securely
tighten
handle
lock lever by rotating
clockwise,
Leav-
ing handle assembly
in highest
position
will make it easier to connect
shift rod_
Flat Washer
Handle Lock
Handle Lock
Lever
Gearcase
Slot
Rear Cartridge
Bolt
Handle Base
Locknut ""i1_-Piv°t
Bolt
INSERT
CABLE
CLIP
• Insert plastic cable clip into hole on the
back of handle column,
Push cables
into clip.
Cable Clip
handEes_14
CONNECT
SHIFT
ROD
1, Insert end of shift rod farthest
from
bend into hole of shift lever indicator.
2, Insert hairpin clip through
hole of shift
rod to secure
with bend of clip on right
side,
('L'_Attach
this End To shift
Lever Indicator
Shift Rod
Shift Lever
Hairpin
ndicator
Shift Rod
REMOVE
TILLER
FROM
CRATE
1_ Adjust
handle assemby
to lowest
position.
Be sure lock lever is tightened
securely.
2,
Make sure shift lever indicator
is in "N"
(neutral)
position,
3. Tilt tiller forward
by lifting handle.
Sep-
arate cardboard
cover from leveling
shield,
4,
Rotate tiller handle to the right and pull
tiller out of carton.
CHECK
TIRE
PRESSURE
The tires on your unit were overinflated
at
the factory for shipping
purposes,
Correct
and equal tire pressure
is important
for
best
tilling performance,
.
Reduce tire pressure
to 20 PSI,
HANDLE
HEIGHT
• Handle
height
may be adjusted
to bet-
ter suit operator,
(See "TO ADJUST
HANDLE
HEIGHT"
in the Service
and
Adjustments
section
of this manual),
Tabla de contenido
