brondell Halo PH10-B Manual Del Proprietário página 14

MAINTENANCE (cont.)
REPLACING THE FILTERS (cont.)
1. Unplug the Halo.
2. Remove the Front Panel by pulling the bottom of the
panel away from the unit. Then push upwards until the panel comes off.
3. Press the two tabs on the Mesh Pre-Filter down and pull
the filter straight out of the Filter Cabinet. Remove the
Carbon Filter from the back side of the Mesh Pre-Filter.
Pull out the True HEPA Filter by the white fabric tab at the
top of the filter.
Thoroughly rinse the Mesh Pre-Filter and let it air dry
before placing it back in the Filter Cabinet.
NOTE: Do not use heated or compressed air as part of
the drying process.
4. Remove all plastic packaging from the replacement filters.
5. Put the filters back into the unit in the following order:
True HEPA Filter (this goes in first)
Carbon Filter
Mesh Pre-Filter
NOTE: Make sure that the white fabric tab labeled
"FRONT" on the True HEPA filter is facing towards
the front of the Halo.
6. Re-attach the Front Panel by inserting the tabs on the top
of the Front Panel into the slots in the top of the body.
Then, push the bottom of the panel towards the unit until
the Front Panel is securely in place.
12
Step 2
Step 3
Step 6