Troubleshooting - Lorex LW1740 Serie Guía Para Usuarios

13

Troubleshooting

Problem
There is no picture
from the camera(s)
The picture is dropping
The picture is or has
become choppy
Video display on the re-
ceiver is turned off
Can't access the main
menu
The picture is white
#LX400030; r. 1.0/17112/17628; en-US
Solution
• Check power to the camera.
• Make sure that the cameras and receiver are both on.
• Make sure that the camera is within range of the receiver.
• The receiver's battery is dead. Connect the receiver to a
power outlet using the included power adapter.
• The camera channel has been de-activated. See 10.5 Acti-
vating / De-activating Channels, page 47 for full instructions
on activating the channel.
• Move the camera(s) closer to the receiver.
• Try repositioning the camera(s), receiver or both to improve
the reception.
• Ensure you have raised the antenna on the receiver.
• The picture may become choppy when experiencing a lower
frame rate due to reduced signal strength (i.e. 10 frames per
second vs. a higher 25 frames per second).
• Try moving the camera(s) closer to the receiver.
• Remove obstructions between the receiver and camera(s).
• Make sure that the receiver is turned on.
• The receiver's battery is dead. Connect the receiver to a
power outlet using the included power adapter.
• Power saving mode is active. Press any button on the re-
ceiver to turn the video display on again.
• The system is recording. The main menu cannot be ac-
cessed while the system is recording. See 8 Recording,
page 20 for details on pausing / stopping recording on the
unit.
• Common situation know as "washout" or "whitewash" where
a strong light source is pointed at the camera lens. The cam-
era lens IS NOT harmed during a whitewash.
• DO NOT point your camera towards a light source.
59