Napa 791-6431 A Manual Del Funcionamiento Y Lista De Piezas

BEFORE USING THIS DEVICE, READ THIS
MANUAL COMPLETELY AND THOROUGHLY,
UNDERSTAND ITS OPERATING PROCEDURES,
SAFETY WARNINGS AND MAINTENANCE
REQUIREMENTS.
It is the responsibility of the device owner to make sure all personnel
read this manual prior to using the device. It is also the responsibility
of the device owner to keep this manual intact and in a convenient
location for all to see and read. If the manual or product labels are lost
or not legible, contact NAPA for replacements. If the operator is not
fluent in English, the product and safety instructions shall be read to
and discussed with the operator in the operator's native language by
the purchaser/owner or his designee, making sure that the operator
comprehends its contents.
SPECIFICATIONS
Maximum Capacity . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Ton
Low Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1/2"
High Height . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 18-3/8"
Chassis Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . 24-1/4"
Overall Width . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-3/8"
Handle Length . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47-1/2"
Saddle Diameter . . . . . . . . . . . . . . . . . . . . . . . . . . 4-5/16"
Shipping Weight . . . . . . . . . . . . . . . . . . . . . . . . . . . 51 Lbs .
791-6431 A
2 Ton ALUMInUM
WARNING
• Read, study, understand and follow all instructions
before operating this device. • Inspect the jack before each
use. Do not use jack if damaged, altered, modified, in poor
condition, leaking hydraulic fluid, or unstable due to loose
or missing components. Make corrections before using.
• Lift only on areas of the vehicle as specified by the
vehicle manufacturer. • Wear eye protection that meets
ANSI Z87.1 and OSHA standards (user and bystanders). • Do
not use jack beyond its rated capacity. Do not shock load.
• This is a lifting device only. Immediately after lifting,
support the vehicle with jack stands capable of
sustaining the load before working on the vehicle.
• Use only on a hard level surface free from obstructions so
the jack is free to reposition itself during lifting and lowering
operations. • Center load on saddle. Be sure setup is stable
before working on vehicle. • Do not move or dolly the vehicle
while on the jack. • Do not use any materials that may serve
as risers, spacers or extenders between the stock lifting
saddle and the load. • Do not use any adapters that replace
the stock lifting saddle unless approved or supplied by the
jack manufacturer. • Do not use (or modify) this product
for any other purpose than that for which it was designed
without consulting the
representative. • Always lower the jack slowly and care-
fully. • This product contains chemicals known to the State
of California to cause cancer and birth defects or other
reproductive harm. Wash hands thoroughly after handling.
• Failure to heed these warnings may result in serious or
fatal personal injury and/or property damage.
Model # 791-6431 A
SERVICE JACK
manufacturer's authorized
rev. 9/16/15