Carpet Height Adjustment; Handle Position; Cleaning Lightweight Flexible Rugs; Stair Cleaning - Hoover U5140900 Manual Del Propietário

Carpet heiGht adjustMent

The cleaning of carpet
2.8
and rugs takes place at
the nozzle (A).
When it is necessary to
raise and lower the
b
nozzle for various
carpet pile heights,
slide the nozzle control
knob (B) to the desired
setting.
settinGs
For maximum cleaning performance, the following
carpet height settings are recommended:
• Lowest setting: or all types of carpet. Note: If the
cleaner is difficult to push, slide knob to the next
higher setting.
• Higher settings: for very deep pile carpet where
easier pushing effort is desired, while maintaining
good cleaning performance.
CleaninG liGhtweiGht
flexible ruGs
Stand on one end of rug and move cleaner toward
other end or edge. Before reaching edge, push
down on handle. This will lift up the nozzle (front of
cleaner) as shown and will prevent rug from clinging
to cleaner. Continue to lift up nozzle so that when
you have reached the edge, it is completely off the
rug. Move cleaner back to start again, lower nozzle,
and use only forward strokes.

stair CleaninG

2.12 Lift vacuum by Stair Cleaning Handle and
position on stairs. Clean forward to back. Never
leave the vacuum standing on stairs when not
cleaning.

handle pOsitiOn

For ease in sliding
2.9
knob, the handle should
be in the upright
C
position (C).
The nozzle will not
move into the adjusted
position until the
a
cleaner handle is
lowered to the operating
position (D).
2.10
HIGH
2.11
2.12
8
d
Hard
Floor