JB Systems PARTY BEAMS Manual De Instrucciones página 8

ENGLISH
 14 CHANNEL MODE: full manual control over each individual projector.
 Connect the DMX input of the PARTY BEAMS to the DMX output of the previous unit in the chain or
directly to the DMX-output of your controller.
 Press the [MENU] button until the display shows: "DMX".
 Press the [ENTER] button to enter this option
 The actual DMX address is shown on the display.
 Press the [ENTER] button again to set the DMX settings
 You can now change the DMX mode
 Use the [UP/DOWN] buttons to select the desired DMX-mode. (3CH, 5CH, 6CH, 9CH or 27CH)
 Press the [ENTER] button to confirm your choice.
 Now you can use the [UP/DOWN] buttons to set the DMX address. [dxxx]
 Press the [ENTER] button to confirm your choice.
Note: the display blinks when the unit is in DMX-mode and no DMX-signal is detected.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light
equipment. You need to "daisy chain" your DMX controller and all the connected light
effects with a good quality XLR M/F balanced cable. To prevent strange behavior of
the light effects, due to interferences, you must use a 90Ω to 120Ω terminator at the
end of the chain. Never use Y-splitter cables, this simply won't work!
Each effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
JB SYSTEMS® 6/55
USER MANUAL
PARTY BEAMS