TFA Dostmann 35.1078.10.IT Manual De Instrucciones página 37

CHECKING FOR 868MHz RECEPTION
If the outdoor temperature and humidity data are not being received within three
minutes after setting up (or outdoor display always show "- -. -" in the outdoor
section of the Weather station during normal operation), please check the
following points:
1. The distance of the weather station or transmitters should be at least 2
meters away from any interfering sources such as computer monitors or TV
sets.
2. Avoid placing the transmitters onto or in the immediate proximity of metal
window frames.
3. Using other electrical products such as headphones or speakers operating
on the 868MHz-signal frequency may prevent correct signal transmission
or reception. Neighbors using electrical devices operating on the 868MHz-
signal frequency can also cause interference.
Note:
When the 868MHz signal is received correctly, do not re-open the battery cover
of either the transmitter or Weather station, as the batteries may spring free from
the contacts and force a false reset. Should this happen accidentally then reset
all units (see "Setting up" above) otherwise transmission problems may occur.
The transmission range is around 100 meters from the thermo-hygro transmitter
to the weather station (in open space). However, this depends on the
surrounding environment and interference levels. If no reception is possible
despite the observation of these factors, all system units have to be reset (see
"Setting up" above).
POSITIONING THE WEATHER STATION
The weather station provides the option of table standing or wall mounting the
unit. Before wall mounting, please check that the outdoor data can be received
from the desired locations.
To wall mount:
1.
2.
Fix a screw (not supplied) into the desired wall, leaving
the head extended out by about 5mm.
Place the weather station onto the screw, using the
hanging hole on the backside. Gently pull the weather
station down to lock the screw into place.
The foldout table stand leg is located on the backside. Pull the
stand out from the bottom center edge of the weather station,
below the battery compartment. Once the foldout table stand is
extended, place the weather station in an appropriate location.
Foldout table stand:
36