Berner 043345 Instrucciones De Uso página 15

A Current measurement indication

Ohm measurement indication
DC DC input indication
AC AC input indication
~
- Polarity indication
Analog bar graph indication
Keypad
HOLD-key: Fixes the display on the current value and memories it (short press).
A second short press returns the clamp meter to normal mode.
AC/DC-key: Selection of the DC (default) or AC mode: press on the key, the beep
sounds briefly.
This key is operative in V range.
ZERO-key: Press Zero-key to enter the zero mode: ZERO annunciate turn on and
Zero the display and the reading is stored as reference value for
subsequent measurement.
Press it again, the ZERO annunciate blinking and memorized
reference value will display.
Press and hold down Zero key for two seconds to exit the zero mode.
When the meter is under the zero mode, the autorange function will
be disabled.
RANGE-key: Selection of the automatic (default) or manual mode: short press on
the kea, the beep sounds briefly.
Switch from manual to autoranging mode: long press on the key, the
beep sounds briefly.
In manual mode, ranges selection: press successively short on the
key. The key is operative in V and A ranges.
Transformer jaws
Pick up the current flowing through the conductor.
Terminals
V/Ω : terminal receiving the red lead for voltage, resistance and continuity
measurements.
COM: terminal receiving the black lead for voltage, resistance and continuity
measurements.
3. Technical Specifications
General specifications
Environment conditions:
Installation categories II, 600V max. to earth.
Pollution degree: 2
14