Manual Code Search; Identifying Codes Found; Configure Volume Control For Various Devices - Marmitek TV ANYWHERE Modo De Empleo

press Prog+ [5] to switch to slow search (1 code per 3 seconds). You can step back by
pressing Prog- [5] (you can step forward by pressing Prog+ [5] in case you went back too
far). As soon as the device responds again, press ENT [11] to store the code you found.
☺
if some functions of your device do not work, you need to try another code for your
brand. The search function starts after the last confirmed code.

7.3.4. Manual code search

Note: You can dedicate any device (TV, DVD, SAT...) to the VCR, CBL, DVD, CD, ASAT, DSAT
or AUX buttons. You first need to enter a code for the type of device you wish to control
(from the code book), i.e. if you want to program a SAT under the AUX button, enter ANY
SAT code from the code book and then follow the steps below:
1. Make sure your device is switched on.
2. Press and hold SETUP [7] until the LED indicator stays lit. Release SETUP.
3. Press the mode button [3] that matches the device you want to control (for example TV).
4. Press Prog+ [5] repeatedly until the channel changes. If you step past the correct code,
use Prog- [5] to go back to the right code.
5. When the device you want to control reacts, press ENT [11] to confirm the code.
☺
If your equipment does not have Prog+, you can use PLAY (VCR or DVD) [19] or POWER
[1]. The search starts after the last registered code. Note: if certain functions of your
equipment cannot be controlled, you will have to find a different code for your brand.

7.4 Identifying codes found

If the batteries have been outside the remote control for a longer period, the programmed
codes may be erased from the memory. It is a good idea to write down the codes, so you can
reprogram the remote control quickly. If you don't know the code (for example because you
found the code by autosearch), you can identify it as follows:
1. Press and hold SETUP [7] until the LED indicator [2] stays lit. Release SETUP.
2. Press the mode button [3] for the device you want to identify (VCR, DVD, ASAT or DSAT).
The LED will flash once.
3. Press SETUP again. The LED will flash once. To identify the first digit, press each number
button from 0-9 [9] until the LED flashes. The number you pressed, is the first digit of the
code.
5. Press each number key from 0-9 as above to find the second digit.
6. Press each number key from 0-9 as above to find the third digit.
7. Press all digit keys again to locate the fourth digit. As soon as the fourth digit is located,
the LED goes off.

7.5 Configure volume control for various devices

The remote control is preset so that the Volume and Mute keys operate the device which is
programmed by the device keys [3]. If the programmed device does not have a volume/ mute
1 6
© MARMITEK