Voice Volume; Setting The Midi Channel; Setting The Click Tone; Touch Sensitivity - Alesis RECITAL Guia Del Usuario

Voice Volume

You can set the volume of each voice in Layer and Split Mode by using Advanced Function Mode.
1. Press the Metronome and Lesson buttons at the same time to enter Advanced Function Mode. The
two button LEDs will be lit.
2. Use the keys marked Upper Volume 1–5 to change the volume of the upper voice in Layer Mode. 1 is
the lowest volume, and 5 is the highest volume.
3. Press both the Metronome and Lesson buttons again to exit Advanced Function Mode.
You can follow the above steps to set the volumes for the lower voice in the Layer Mode and the split voice
in the Split Mode, using the Lower Volume 1–5 and Split Volume 1–5 keys respectively.

Setting the MIDI Channel

You can also set the MIDI channel for the USB-MIDI output by using Advanced Function Mode.
1. Press the Metronome and Lesson buttons at the same time to enter Advanced Function Mode. The
two button LEDs will be lit.
2. Use the keys marked MIDI Ch + or MIDI Ch - to set the MIDI Out channel from Channels 1–16. Press
both keys at the same time to restore the default channel setting to 1.
Note: Recital uses only one MIDI channel at a time, even if you are using Split Mode or Layer Mode.
3. Press both the Metronome and Lesson buttons again to exit Advanced Function Mode.

Setting the Click Tone

When the click tone is on, you will hear a click sound whenever you change a setting or parameter. You can
turn the click tone on or off in Advanced Function Mode.
To turn the click tone on or off:
1. Press the Metronome and Lesson buttons at the same time to enter Advanced Function Mode.
The two button LEDs will be lit.
2. Press the key marked Click to turn the tone on or off.
3. Press both the Metronome and Lesson buttons again to exit Advanced Function Mode.

Touch Sensitivity

The Recital digital piano is equipped with touch response to control the level of the voice with your playing
strength—just as on an acoustic piano. That means the harder you play the keys, the greater volume comes
from the speakers. Turning this function off results in a fixed touch response no matter how hard or how soft
you play the keys. There are 3 types of touch settings (Off, 1–3).
To set the touch sensitivity:
1. Press the Metronome and Lesson buttons at the same time to enter Advanced Function Mode.
The two button LEDs will be lit.
2. Use the Touch keys to select an appropriate touch level.
3. Press both the Metronome and Lesson buttons to exit Advanced Function Mode.
Parameters
OFF
1
2
3
Description
Fixed
Soft
Medium
Hard
7