Voice Volume; Setting The Midi Channel; Setting The Click Tone - Alesis RECITAL 61 Guía De Usuario

Voice Volume

You can set the volume of each voice in Layer Mode and the split voice in Split Mode.
To set the volume of the upper voice in Layer Mode:
1. Press the Metronome and Lesson buttons at the same time to enter Advanced Function Mode.
The two button LEDs will be lit.
2. Following the diagram on page 7, use the keys marked Upper Volume 1-2-3 to set the volume.
1 is the lowest volume, and 3 is the highest volume.
3. Press both the Metronome and Lesson buttons again to exit Advanced Function Mode.
To set the volume of the lower voice in Layer Mode or the split voice in Split Mode: Follow the
steps above but instead use the Lower Volume 1-2-3 or Split Volume 1-2-3 keys.

Setting the MIDI Channel

You can also set the MIDI channel for the USB-MIDI output.
To set the MIDI Out channel:
1. Press the Metronome and Lesson buttons at the same time to enter Advanced Function Mode.
The two button LEDs will be lit.
2. Following the diagram on page 7, use the keys marked Midi Ch. - or Midi Ch. + to set the MIDI
Out channel from 1–16. Press both keys at the same time to restore the default channel setting
to 1.
Note: Recital 61 uses only one MIDI channel at a time, even if you are using Split Mode or Layer
Mode.
3. Press both the Metronome and Lesson buttons again to exit Advanced Function Mode.

Setting the Click Tone

When the click tone is on, you will hear a click sound whenever you change a setting.
To turn the click tone on or off:
1. Press the Metronome and Lesson buttons at the same time to enter Advanced Function Mode.
The two button LEDs will be lit.
2. Following the diagram on page 7, press the key marked Click to turn the tone on or off.
3. Press both the Metronome and Lesson buttons again to exit Advanced Function Mode.
8