Tabla de contenido
Engine
Perform the following steps to protect the cylinder, piston ring, etc. from
corrosion.
1. Remove the spark plug, pour about one table-spoon of SAE
10W-30 or 20W-40 motor oil into the spark plug hole and
reinstall the speak plug. Recoil start the engine by turning over
several times (with ignition off) to coat the cylinder walls with oil.
2. Pull the recoil starter until you feel compression. Then stop
pulling. (this prevents the cylinder and valves from rusting).
3. Clean exterior of the generator and apply a rust inhibitor.
4. Store the generator in a dry, well-ventilated place, with the cover
placed over it.
5. The generator must remain in a vertical position when stored,
carried, or operated
6. Remove the screws ①, and
then remove the cover ②.
7. Drain the fuel from the
carburetor by loosening the
drain screw ③ on the carburetor
float chamber.
8. Turn the Engine switch to
"OFF"
9. Turn the fuel cock knob to
"OFF"
10. Tighten the drain screw
11. Install the cover and tighten the
screws.
12. Turn the fuel tank cap air vent
knob to "OFF"
13. Store the generator in a dry,
well-ventilated place, with the
cover placed over it.
6-2
Tabla de contenido
