STEERING ADJUSTMENT
If the vehicle pulls to the left or right,
press the trim buttons in the opposite
direction as many times as necessary
until the vehicle drives straight.
WHEEL CHANGE
Press the retainer to pull the wheel off.
When replacing the wheel, make sure
the hex engages properly in the rim.
STEERING CONVERSION
The wheel can be switched for left-
handed drivers.
1. Press wheel retaining clamps together.
2. Pull wheel upward and off.
Problem: The car does not move.
Cause: The battery is too weak or depleted.
Remedy: Charge the battery (see "Charging the Vehicle").
Problem: The vehicle cannot be controlled with the controller.
Cause: The controller is switched off. The connection between the
controller and vehicle has been severed.
Remedy: Move the controller switch to the "ON" position.
Re-establish connection between the vehicle and controller.
4
3. Install the wheel to the opposite
side.
BATTERY SAVER
After 5 minutes of no use, the controller
makes a tone and the LED blinks. After
an additional 5 minutes, it switches off.
The vehicle switches off approximately 3
minutes after the controller. To resume
driving, switch the controller and vehicle
off and on again.
CONNECTING THE VEHICLE
AND CONTROLLER
The connection of your vehicle and
controller is established at the factory.
If necessary to re-establish connection,
proceed as follows:
1. Switch off the vehicle.
2. Switch on the controller.
3. Press and hold the right trim button
and ON/OFF button for approximately
fi ve (5) seconds until the controller
beeps and the LED blinks.
4. Place the controller directly next to
the vehicle and switch the vehicle on.
5. When the LED on the controller
illuminates continuously, the
connection has been established.
TROUBLESHOOTING
Problem: Controller does not work.
Cause: The controller is switched off. The batteries were not inserted
correctly. The batteries do not have enough power.
Remedy: Repeat the switch-on process as described. Check that
the batteries are inserted correctly.
Problem: The vehicle slows down and stops for no apparent reason.
Cause: The vehicle battery is too weak.
Remedy: Charge the battery.
CONNECTING TO YOUR
COMPUTER
Connecting the controller to your
computer.
1. Switch the vehicle off.
2. Switch on the controller.
3. Press and hold the right trim button
and ON/OFF button for 5 seconds,
until the controller beeps and the
power LED blinks.
4. Remove the USB receiver from the
back of the controller base and insert it
into an open USB port on your
computer. Place the controller directly
next to it.
5. As soon as the power LED on the
controller illuminates continuously, the
connection has been established. This
process can take a few minutes.
6. Visit revell.com to play the racing
video game!
SERVICE
If your Revellutions Kit requires repairs or
replacement, DO NOT RETURN TO
RETAILER. Contact:
Hobby Services
3002 N. Apollo Drive, Suite 1
Champaign, Il, 61822, U.S.A.
9am-5pm Central Mon.-Fri.
(217) 398-0007