5 INSTALLATION SITE
PREPARATION
5.1 GENERAL INFORMATION
The following paragraphs provide instructions that
must be complied with in order to ensure maximum
ef¿ ciency of the product purchased.
The following instructions are however subordinate
to compliance with any national, regional and local
laws and standards in force in the country where
the product is installed.
5.2 SAFETY PRECAUTIONS
Responsibility for work carried out in the place
where the stove is installed lies with the user;
the user is also responsible for making sure the
installation checks are completed.
The user must abide by all local, national and
European safety requirements.
The appliance must be installed on À oors with a
suitable load-bearing capacity.
The stove assembly and dismantling instructions
are reserved exclusively for specialist technicians.
Users should always contact our service centre
to request work to be performed by qualified
technicians.
Before having work performed by other technical
personnel verify their effective technical
competence. Before starting to assemble or
dismantle the stove, the installer must heed the
safety precautions required by law, speci¿ cally:
A) do not work in adverse conditions;
B) always be in a ¿ t mental-physical state for
working and make sure that personal protective
equipment is in perfectly working order;
C) always wear safety gloves;
D) always wear safety shoes;
E) always use electrically insulated tools;
F) make sure that the area being used for assembly
and dismantling is clear of any obstacles.
38/144
INSTALLATION
INSTALLATION MANUAL
5.3 STOVE INSTALLATION SITE
Fig. 5.1 and the corresponding table show the
minimum clearances from combustible materials
and objects expressed in centimetres that must
be observed when positioning the stove; for non-
À ammable walls/objects, these clearances can be
halved.
A) Adjacent wall.
B) Rear wall.
C) Side wall.
D) Protective À ooring.
Type of pellet stove
Corridoio series
Angolo series
30 y 50
Silent series
Ermetica series
Classica series
Check the type of stove in the product booklet enclosed.
Protect all structures that may catch ¿ re if exposed
to excessive heat.
Floors made from À ammable materials such as:
wood, parquet, linoleum, laminates or carpets
must be protected by a suitably-sized ¿ reproof
base underneath stove. Such base may be made
from steel, slate, glass or stone and must cover the
À oor in the part underneath the stove and the À ue
attachment, and must extend at least 50 cm at the
front.
The manufacturer declines all liability for any
alterations to the characteristics of the material
making up the À oor underneath the protective base.
- cod. 004770810 - 09/2011 - Palazzetti - PN - Italy
B
c
D
Fig. 5.1
a
b
c
d
60
2
60
30 y 50
2
2
30 y 50
20
20
20
30 y 50
20
20
20
30 y 50
20
20
20
30 y 50