Troubleshooting - H.Koenig V26 Manual De Utilización

water.
· If the water is very dirty, repeat the operation until it is clean.
· Checking that the seal is present and that the cap is screwed on properly.
· Fill the water tank again.
· Turn the appliance on again.
· Before ironing, release steam into the sink or another container and check that the steam is
clean. This should take a few seconds.
· Resume ironing normally.

TROUBLESHOOTING

PROBLEM
Water comes out of the iron
instead of steam
The appliance is on but it is not
producing steam
Suggestions
Divide the washing according to the correct ironing temperatures. Start by ironing those garments
that require a lower temperature. For fuller details, refer to the chart at end of this booklet.
Fabrics such as velvet and wool, and accessories such as gloves, handbags, etc. will regain their
brand-new look and texture by simply passing the iron near the surface of the fabric and pressing
the steam button.
Imprints left in carpets by furniture can be removed by applying steam on the parts where the pile is
crushed and the brushing lightly.
If the carpet is made of synthetic material, do not select a high temperature.
How to get a professional ironing finish
A normal iron generates only a small quantity of steam. In this case it is necessary to products
steam constantly in order to eliminate crease in the fabric being ironed.
A professional ironing system works rather differently. The fabric is first made damp by the
steam and then, in a second phase, dry-ironed in the normal way. This means that every.
Tiniest crease is removed and your garments are ironed to perfection.
In the first phase (steam-damping of the fabric),hold the iron about 20 cm above the fabric and
press the steam(3). Pass the iron over the garment in a circular movement so that the powerful
jet of steam damps the fabric. Lightly creased garments require only a few moments of
steaming. While very heavy fabrics or garments with particularly difficult creases must be
damper, so steam must be applied for a few seconds more.
During the second phase (dry ironing), check that the thermostat knob is in the correct position
for the type of fabrics; release the steam button(3) and dry-iron the garment. The special
ironing plate will prevent the fabrics from becoming shiny. Using this ironing technique, and
following the suggestions in the chart below, you will find it easy to give your garments a really
professional ironing finish.
CAUSE
The appliance has not reached
the right temperature yet.
The temperature control dial
has set at the minimum.
Water tank is empty or not
inserted correctly.
SOLUTION
Wait for the "Steam Ready"
indicator light and the iron
indicator light to turn off.
Increase the regulation of the
temperature control dial.
Fill the water tank.