Tool And Work Area Set-Up - Emerson RIDGID RP 210 Manual Del Usuario

RP 210 Press Tool
properly inspect and maintain attachments and charg-
ers can result in serious injury and property damage.
5. Check that the warning label is present and firmly
attached to the tool and if required, the battery. Do not
operate the press tool without the warning label. See
Figure 2 for the location of the press tool warning
label. Figure 3 shows the labels on the bottom of the
batteries.
Figure 2 – Press Tool Warning Label
Figure 3 – Label On Bottom Of Battery
6. With dry hands, insert a fully charged battery. Press
the ON/OFF button on the LED panel one time to turn
the press tool ON. The green, red and yellow LED on
the display panel should all blink one time on power
up, and then the green LED will remain on to indicate
that the tool is ready for use. For use in cold weather
(temperatures below 15°F (-10°C)), see Cold Weath -
er Operation Section . If any other conditions exist, use
the Diagnostic Codes information on Page 12 to
determine the next step and do not use the tool until
it is working properly. With your hands and fingers
away from the tool ram, test the operation of the
switch to confirm proper operation. When used with
an attachment, once the tool sees enough load it
will lock on to insure that a complete press is made.
Once the operation has been checked, with dry
hands remove the battery.
6

Tool And Work Area Set-Up

WARNING
Set up the press tool and work area according to
these procedures to reduce the risk of injury from
electric shock, fire, crushing injuries and other
causes, and prevent tool and system damage.
1. Check work area for:
• Adequate lighting.
• Flammable liquids, vapors or dust that may ignite.
If present, do not work in area until sources have
been identified and corrected. The press tool is
not explosion proof and can cause sparks.
• Clear, level, stable and dry place for operator. Do
not use the machine while standing in water.
2. Inspect the work to be done and determine the correct
RIDGID tool and attachment(s) for the application.
Using an incorrect attachment for an application can
cause injury, damage the tool and make incomplete
connections. For a complete listing of RIDGID attach-
ments available for this tool, see the Ridge Tool
Catalog on line at www.RIDGID.com or call Ridge
Tool Technical Services (800) 519-3456. Make sure
that the tool and attachment have been inspected as
directed in their instructions.
3. Evaluate the work area and determine if any barriers
are needed to keep bystanders out. Bystanders can
distract the tool operator during use.
4. Confirm that the battery is removed and fully open the
attachment mounting pin. See Figure 4. If there is an
attachment in the tool, slide it out of the tool.
5. Slide the correct attachment into the press tool as
shown in Figure 5 and fully close the attachment
mounting pin. The tool will not operate unless the
mounting pin is fully closed.
Figure 4 – Fully Open Attachment Mounting Pin