GE GXSH4OV Manual De Instalación página 15

Installation Instructions.
ADD WATER AND SALT TO THE SALT
STORAGE TANK
WARNING!
EXCESSIVEWEIGHT HAZARD:
Use two or more people to move end lift
solt bogs. Failure to do so con result in
beck or other injuries.
1. Using a container, add about three gallons of
clean water into the salt storage tank.
2. Add salt to the storage tank. Use nugget,
pellet or coarse solar salts with less than 1%
impurities.
PLUG IN THE WATER SOFTENER
1. Plug the water softener into an electrical outlet
that is not controlled by a switch.
2. Replace the top cover.
3. Replace the salt hole cover.
NOTE: The water heater is filled with hard
water and,as hot water is used, it will refill
with conditioned water. In a few days, the hot
water will be fully conditioned. To have fully
conditioned hot water immediately, wait until
the initial recharge is over. Then, drain the water
heater(following instructions for water heater) until
water runs cold.
-- WARNING!
Discard all unused parts
and packaging material after installation.
Small parts remaining after the installation
could be a choke hazard.
SANITIZE THE WATER SOFTENER/SANITIZE
AFTER SERVICE
1. Open salt hole cover, remove the brinewell cover
and pour about 3 oz. (6 tablespoons) of household
bleach into the softener brinewell. Replace the
brinewell cover.
2. Hake sure the bypass valve(s)is in the
"service"(open) position.
3. Start a recharge (regeneration). See"Start a
Recharge'on Page 13.
4. After the recharge has completed, fully open a
cold water faucet, downstream from the softener,
and allow 50 gallons of water to pass through
the system. This should take at least 20 minutes.
Closethe faucet.
15