Vertiv LIEBERT GXT5-3KL620RT2UXL Guía De Instalación Rápida página 2

LIEBERT® GXT5™ UPS 208-V 3,000 VA
Quick Installation Guide
GXT5 UPS to External Battery Cabinet Connections
TM
GXT5‑3KL630RT2UXL
Single/First EBC
Second EBC
CONNECTIONS
4. Connecting External
Battery Cabinet
(Optional)
External battery cabinets (EBC)
provide longer battery run-time
for connected devices. Refer to
GXT5 User Guide, to select the
appropriate model and quantity
for your GXT5 model and
applications.
• Verify that the EBC breaker
is in the "Off" position.
• Connect one end of the
supplied EBC cable to the
UPS and one end to the
battery cabinet. If connecting
more than one external
battery, connect one end of
the external battery cable to
the second connector on the
battery cabinet, then
connect the other end to the
next battery cabinet.
5. Connecting the UPS
to Receptacle
The UPS is cord and plug
connected using an L6-20P or
L6-30P input plug depending
on your model. Perform all
wiring in accordance to all
local and national electrical
codes.
2
SL-70377_REV1_9-19
EBC‑detection
dry‑contact port
Shown
WIRING
Model
GX5-3KL620RT2UXL
GX5-3KL630RT2UXL
The UPS is equipped with output
receptacles. Connect the
equipment to be protected to the
output receptacles.
NOTE: Allow the batteries to
charge at-least 8 hours before first
start-up to ensure adequate
back-up time. The batteries charge
when the UPS is connected to AC
input regardles of the off/on status
of the UPS.
POWERING THE UPS
NOTE: Do not start the UPS until
after the installation has been
finished, the system is
commissioned by an authorized
engineer, and the external input
circuit breakers have been closed.
1. Make sure the breaker
supplying power to the UPS is
closed, and close the input
breaker on the rear of the UPS.
EBC terminal
Recommended external over-current protection
Operation and Display Panel
(Maximum)
20 A
30 A
Display
screen
Alarm
Run Power
Up Enter
Escape Down