Uline H -7033 Manual De Instrucciones página 2

3. Insert top support bracket (4) into outside of
adjustable frame (2). Repeat this step on the
opposite side. (See Figure 2)
NOTE: Steel lip with three holes on top support
bracket should be facing down.
Figure 2
4
4. Insert two M6 x 33 mm machine screws (9) into holes on
end of adjustable frame to connect adjustable frame
with lifting columns and top support bracket and
lightly tighten using 5 mm hex wrench (13). Then lightly
tighten two pre-installed M6 x 33 mm machine screws (9)
to secure lifting column. Repeat this step on the
opposite side. (See Figure 3)
NOTE: To prevent alignment issues during this
step, do not tighten completely until all four
machine screws are inserted.
Figure 3
9
PAGE 2 OF 15
ASSEMBLY CONTINUED
5. Attach foot (3) to lifting column using four M6 x 15 mm
2
6. Place desktop (1) upside down on a smooth,
7.
13
machine screws (10). Tighten using 4 mm hex wrench (12).
(See Figure 4)
Figure 4
12
Lifting
Column
non-marring surface to prevent scratching.
Grommets should be facing down.
Place adjustable frame on top of desktop (1). Adjust
position of adjustable frame so that it is centered on
the desktop. (See Figure 5)
NOTE: Adjustable frame is designed to fit desktops
that are 48-72" long and 24-30" wide. Extend
adjustable frame as needed to position desktop.
For 48 x 24" and 60 x 24" desks, top support
brackets should be approximately 1½" from side
edges of desktop and approximately 2½" from
front and back edges of desktop.
For 48 x 30" and 60 x 30" desks, top support
brackets should be approximately 1½" from side
edges of desktop and approximately 5½" from
front and back edges of desktop.
For 72 x 24" desks, top support brackets should
be approximately 6" from side edges of desktop
and approximately 2½" from front and back
edges of desktop.
For 72 x 30" desks, top support brackets should
be approximately 6" from side edges of desktop
and approximately 5½" from front and back
edges of desktop.
Figure 5
10
3
1
0720 IH-7033