Establish Mains Contact - Kärcher BR 30/4 C Manual De Instrucciones

Application
Everday cleaner, alkali-
based
Everyday cleaner, acid-
ic, for sanitary applica-
tions, swimming pools,
etc. Removes limestone
deposits.
Remove the fresh water reservoir 
from the appliance.
Open the cover of the fresh water

reservoir.
Pour in water/detergent mixture.

Maximum temperature of the liquid
50 °C.
Close the cover of the fresh water

reservoir.
Insert the fresh water container into

the appliance.

Establish mains contact

Swivel bottom cable hook upward

and remove cable.
Check mains cable and plug for

damage or breakage. Get them re-
placed only through customer ser-
vice agent or an electrician.
Insert the mains plug into the sock-

et.
Cleaning
DANGER
Risk of injury on account of electric
shock caused by a damaged mains ca-
ble. Do not let the mains cable come in
contact with the rotating brushes.
CAUTION
Risk of damage to the floor covering.
The cleaning method for severe soiling
must only be used on floors suitable for
this kind of cleaning.
8
Risk of damage to the fresh water
Detergent
pump if it runs dry because of empty
RM 743 fresh water reservoir. Monitor the fill
level indicator and switch the water
pump switch off if the fresh water res-
RM 738
ervoir is empty.
Normal soiling





Severe soiling
CAUTION
Risk of damage to the floor covering.
The cleaning method for severe soiling
must only be used on floors suitable for
this kind of cleaning.


Vacuuming in corners (BR 30/4 C
Adv only)


– 6
EN
Move the suction bar lift pedal to
position „suction off" (Fig. 3 - posi-
tion "1/ON", see inside front cover).
Press the park position release and
swivel the handle toward the rear.
Set main switch for brush/vacuum
operation to "1".
Activate the water pump switch.
Move the appliance over the sur-
face to be cleaned.
Move the vacuum bar lift pedal to
position „do not suction off" (Fig. 3 -
position "0/OFF" see inside front
cover) and perform the cleaning as
you would with normal soiling. The
detergent liquid remains on the sur-
face to be cleaned and has time to
settle in.
Move the vacuum bar lift pedal to
position "suction off" and reclean
the surface.
Pull the suction tube out toward the
top, attach the suction nozzle and
vacuum the dirt.
Remove the nozzle, replace the
suction tube and insert handle.