POWER PRO BETEK Power Probe 3EZ Manual De Instrucciones página 22

MODES
Mode #3 Max Peak Mode: The Max Peak Mode monitors the
probed circuit and captures the highest detected voltage.
Place the PP3EZ into Max Peak Mode by selecting MAX PEAK
from the menu. Probe the circuit and the PP3EZ instantly dis-
plays and holds the highest voltage reading. This means you
can remove the probe away from the circuit and the voltage
reading remains displayed for your reference. You can reset
the Max reading on the LCD display by doing a quick tap of
the left button.
An APPLICATION for the use of the Max Peak Mode: Let's say
you have a circuit that is supposed to be off and is suspect-
ed of turning on inappropriately or getting a signal for some
reason. Probing the circuit and monitoring it in the Max Peak
Mode will instantly indicate as the circuit increases in voltage.
You can monitor the circuit while wiggling wires and pulling on
connectors to see if the voltage increases. Since the maxi-
mum voltage reading is captured and held on the display, you
can inspect the reading at a later time.
Mode #4 Min Peak Mode: The Min Peak Mode monitors a
positive circuit and displays the lowest voltage that it has
dropped to. To do this: Place the PP3EZ into Min Peak Mode
by selecting MIN PEAK from the menu. The display will show
00.0 volts if the probe tip is not connected to any voltage.
Probe the positive circuit you want to test and press the left
button to reset the voltage reading. The LCD display will show
the lowest detected voltage of the circuit. If the circuit drops
in voltage anytime, a new lowest reading will be captured and
displayed. You can continue to reset the voltage display by
22
WWW.POWERPROBETEK.COM