Activating Components In Hand - POWER PRO BETEK Power Probe 3EZ Manual De Instrucciones

ACTIVATING COMPONENTS IN HAND

While the PP3EZ is in Voltmeter Mode and by using the Power
Probe tip in connection with the auxiliary ground lead, com-
ponents can be activated right in your hand, thereby testing
their function. Connect the negative auxiliary clip to the neg-
ative terminal or ground side of the component being tested.
Contact the probe to the positive terminal of the component,
the green negative sign "-" LED indicator should light GREEN
indicating continuity through the component.
While keeping an eye on the green LED negative sign, quickly
depress and release the power switch forward (+). If the green
negative sign "-" LED went out and the red positive sign "+"
came on, you may proceed with further activation. If the green
negative sign "-" LED went off at that instant or if the circuit
breaker tripped, the Power Probe has been overloaded. This
could happen for the following reasons:
• The contact you are probing is a direct ground or negative
voltage.
• The component you are testing is short-circuited.
•The component is a very high current component (i.e., starter
motor).
If the circuit breaker is tripped, reset it by waiting for it to cool
down (15 sec.) and then depressing the reset button.
11
WWW.POWERPROBETEK.COM