Tabla de contenido
Idiomas disponibles
Idiomas disponibles
A .
INPUT — Plug your guitar in here.
B .
VOLUME — Adjusts the loudness of the Clean channel.
C .
TREBLE / BASS — Adjusts the tone character of the Clean
channel.
DRIVE * — Selects the Drive channel, as indicated by the LED.
D .
E .
GAIN — Adjusts the distortion level of the Drive channel.
F .
VOLUME — Use together with the Gain {E} knob to control the
loudness of the Drive channel.
G . TREBLE / MID / BASS — Adjusts the tone character of the
Drive channel.
H . REVERB * — Adjusts the level of the Reverb effect.
I .
EFFECTS ADJUST — Press to adjust either Chorus or Delay
using the Time/Rate, Mix and Depth knobs.
NOTE: You must turn to activate the Time/Rate, Mix and
Depth knobs after you switch between effects, otherwise the
knob positions will not show the actual settings for the newly
selected effect.
*
Footswitchable: You can activate this control remotely from the included 4-button footswitch!
Vacuum Tubes
Your new Fender® amplifier comes equipped with the highest
quality tubes available, sourced from various manufacturers all
over the world. Because of occasional irregularities in supply,
the specific tube type used in each amplifier is subject to
change without notice.
When replacing output tubes, please note the specific tube
markings on the original tubes factory supplied with your
amplifier. For example, 6L6 output tube types used by Fender
include, but are not limited to: 6L6GC; 6L6WXT; 6L6C; 6L6GE;
etc. The installation of a different type may require significant
adjustment by a qualified technician to avoid reduction in
performance and tube life.
Additionally, Groove Tubes™ sorts and tests many of our
output tubes, and paints them with a color-coded label. If
your amp came supplied with, for example, White-labeled
Front Panel
J .
TIME/RATE —
Delay: Adjusts the interval between delayed repeats.
Chorus: Adjusts the speed of the chorus sweep.
DELAY * — Press to activate the Delay effect, as indicated by
K .
the LED.
L .
MIX — Adjusts the level of the Delay and Chorus effects. The
Chorus effect in the VM amplifier will deliver a chorus effect
with Mix set near the center of its range, or a true pitch-
shifting vibrato effect with Mix set to "10."
M . CHORUS * — Press to activate the Chorus/Vibrato effect, as
indicated by the LED.
N . DEPTH —
Delay: Adjusts the number of delayed repeats.
Chorus: Adjusts the intensity of the chorus/vibrato effect.
O . POWER JEWEL — Indicates the amplifier is on.
6L6WXT tubes, then a new set of White 6L6WXT tubes will
be the perfect direct replacement.
If you have questions or concerns, contact your Fender dealer
or authorized service center.
Tube locations left to right at rear:
fender.com
�����
�����
�����
�����
��
��
��
��
��
��
7
Tabla de contenido
