Troubleshooting; Technical Data; General; Wireless Remote Control - Laerdal Resusci Anne Instrucciones De Utilizacion

Ocultar thumbs Ver también para Resusci Anne:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 18
1. Attach IV bag to IV tubing.
2. Attach IV tubing to either vein.
3. Allow fluid to flow through arm and out other vein.
4. Clamp off flow of water from open vein.
The arm is now ready to practice venipuncture.
A 22 gauge needle or smaller is recommended to extend the life of
the IV Arm.
When using an IV catheter, lubricate with manikin lubricant for easi-
er insertion.
When excessive leaking occurs at puncture sites, either a new vein
system or skin should be installed to reduce loss of fluid.
We recommend working at a sink when replacing the skin and vein
system.
Replacing Skin and Veins:
If replacing both skin and veins, cut off skin. This can be done with a
sharp knife, scalpel or scissors. When finished, discard skin.
Replacing veins: (Keeping skin)
1. Lubricate inside of skin with liquid detergent; let it flow down
into the finger area.
2. Begin at top of arm and slowly pull skin down and off of arm.
Do not roll, as that will cause skin to bind.
3. Remove tubing from track in mandrel.
Glue may need to be scraped away to allow removal.
4. Rinse and dry vein grooves well and swab with alcohol.
Be sure to remove any excess glue.
5. Place new veins along grooves, spot gluing as needed.
(We recommend fast-drying glue.)
6. Generously lather arm mandrel with liquid soap.
7. Slide hand into skin.
8. Work skin over fingers, as with a glove.
9. Work arm skin up, over mandrel.
Heat arms skins before replacing on mandrel. This can be done with
a blow-dryer.

Troubleshooting

If an error message appears on the remote control stating "no
reception", make sure that the simulator is turned on.
If spontaneous breathing is activated and no chest rise is observed,
make sure that there is enough air in the air container. Check also
that the breathing bladder has no leakage.

Technical Data

General

Operating Temperature
0°C - 40°C at 90% relative humidity, non-condensing
Storage Temperature
-15°C - 50°C at 90% relative humidity, non-condensing

Wireless Remote Control

Batteries:
4 AA type (LR6) Alkaline batteries
Battery life:
Approximately 20 hours
LCD Display:
• High resolution LCD display w/backlight.
Operation range:
• 10m (30 ft) maximum
Radio Frequency (RF) Communication
• Europe: 868.0 - 868.6 MHz (CE approved)
• US and other markets: 915.5 - 916.4 MHz (FCC approved)

Resusci Anne Simulator

Batteries:
8 D-cell (LR20) Alkaline batteries
Battery life:
Approximately 40 hours
(depending on use of torso features)
Blood pressure accuracy:
Defibrillation:
Emergency Cardiac Simulation
• Synchronized variable heart rate, rhythm, abnormalities
and duration
• Defibrillation (25 -360 J)
• Scenario details, including CPR performance, downloadable
to PC software
IV Arm
• Accessible veins include median, basilic and cephalic
15
+/- 2mm Hg
Average of 720J/minute max
Tabla de contenido

Solución de problemas

loading

Tabla de contenido