Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3 41 01 169 21 0.book Seite 21 Mittwoch, 7. September 2011 3:32 15
Feed without the spoke handle (Fig. 16).
Depending on the application, the feed
can also be actuated without the spoke
handle. For this, apply the socket
wrench.
With the motor running, manually
turn the socket wrench.
Instructions for core drilling.
Only remove the cutting tool from the hole
while the motor is running.
If the carbide tipped cutter should remain
stuck in the material, stop the drill motor and
carefully turn the carbide tipped cutter out
clockwise.
Remove the chips and the slug after each dril-
ling process.
Do not touch the chips with your bare
hand. Always use a chip hook.
When changing a cutting tool, pay attention
not to damage the cutting edges.
When core drilling layered material, use a
Slugger ID sharpened cutter for stack drilling.
Fig. 16
30 mm
en
21
Tabla de contenido
