DOMUS LINE MISS Manual De Instalación página 10

INSTALLATION MANUAL
MISS is a switchless component; therefore, it must be switched on
using a separate switch.
- If it is necessary to connect more than one device to the power
supply, ensure that the total sum of the power absorbed by the
luminaires (refer to the data indicated on the nameplate of the
product label), does not exceed the maximum permitted by the
converter.
- DOMUS Line guarantees the product only if supplied with its own
power supply converter.
HOW THE MISS IR IS OPERATED (IR sensor) tab. T1
The luminaire is simply switched on with opening of the door that is
positioned in front of the sensor.
The luminaire is switched off 10 seconds after the door is closed.
The luminaire has a safety program that switches the MISS IR off
after 2 hours of continuous operation with the door open.
WARNING: This luminaire must be connected directly to the
electricity power supply and must never be connected downstream
of other electronic switches, or be positioned near electromagnetic
sources, or be exposed to light beams.
HOW DOES THE MISS SD (TOUCH-DIMMER) WORK?
- MISS SD includes an electronic dimmer switch that can be
switched on and off and that can adjust light intensity
- The device is simply switched on and off by quickly touching its
screen, under wich the switch (B) is placed, which is always
located at the end of the profile
(figure 5).
EN
- A prolonged touch can increase or decrease the device's
brightness and a short flash of the device indicates that its
maximum brightness has been obtained.
- The brightness level obtained will be recalled until the next
adjustment.
- MISS SD device has a safety program that switches itself off after
18 hours of continuous operation.
- MISS IR and MISS SD must be connected directly to the
electricity power supply and must never be connected
downstream of other electronic switches, or near to
electromagnetic sources.
WARNING:
The LED module, the power cable or whichever switch (MISS SD
electronic switch or limit switch sensor MISS IR) is being used are
not replaceable, therefore in case of damage the device must be
entirely replaced.
WARRANTY:
The warranty on the device is valid only if powered by a power
supply provided by DOMUS Line. The warranty's general terms and
conditions for this device are available at www.domusline.com