Idiomas disponibles
Idiomas disponibles
INSTALLATION MANUAL
- ATTENTION: position the supports (4) as per the measurements shown
in figure 9.
- Graft the lamp to the stirrups (4) up to when it will be stopped by the
hook on them, making the cable pass as shown in the detail "A".
- If you need to remove the lamp from the cabinet, insert a tool in the
side holes (6) on the heads, press on the hook and at the same time pull
the lamp towards you. This is to be done on both sides of the device
(fig.10).
WARNING:
This item must be connected directly to the electronic power supply
and must never be connected downstream of other electronic switches.
The sensor must not be installed near electromagnetic sources, heat
sources or exposed to direct sunlight
HOW DOES LEAF-SUNNY TLD (TOUCH-LED-DIMMER) WORK?
After powering the device, the electronic switch TLD will perform an
adjusting self-test of the duration of about 20 seconds. After this time,
it will flash a few times and then it will be ready for the use.
The devices connected to the TLD are turned on and off simply by
rapidly touching the TLD sensitive switch, while a prolonged touch
adjusts the light intensity by increasing or decreasing it. A brief flash of
the TLD indicates that the maximum luminosity has been reached.
The luminosity level obtained will be saved until the next adjustment.
The TLD features a "night-light" function. It consists of a signalling light
of the TLD that activates only when the LEDs are off. When the
environmental light is normal or bright, the TLD emits a dimmed light.
With low or absent environmental light, the TLD emits a more intense
light. While the LEDs are in operation, the light emitted by the TLD will
be proportional to the adjustment selected for the same LEDs.
The "night-light" function can be activated or deactivated by touching
the TLD for 15 seconds; after this, the deactivation of the function will
be signalled by 2 slow flashes, while its activation by 3 fast flashes.
EN
The appliance is fitted with a safety program that turns off the LEAF-
SUNNY after 18 hours of continuous operation.
HOW DOES LEAF-SUNNY DR-US WORK?
Once powered, the switch carries out a self-test for about 40" after
which the device is ready for normal operation.
Start-up and switching off the device is via the sensor (7) that detects
the presence of the door in front and turns the device off after 10
seconds from closing, starting it up again when the door is reopened. If
the door is open all the time the device switches off automatically after
15 min of operating.
WARNING:
This item must be connected directly to the electronic power supply
and must never be connected downstream of other electronic switches.
The sensor must not be installed near electromagnetic sources, heat
sources or exposed to direct sunlight
HOW DOES LEAF-SUNNY IFR WORK?
After 40" from the first lighting the sensor is ready for the normal
operation.
The appliance is turned on and off though the presence sensor
IFR.Detection field must not be obstructed by shelves or object
positioned too close of the sensor (fig.13)
The sensor detects temperature changes combined to the movement of
people, animals and objects with a temperature of approx. 36°C in the
radius of action as shown in figure 14. In this case the sensor activates
turning on the connected LEAF IFR/SUNNY IFR. The system remains in
function for 30 seconds. After that, if it does not detect other
movements, it turns off automatically.
