Idiomas disponibles
Idiomas disponibles
INSTALLATION MANUAL
¹ This installation manual contains instructions valid for all
configurations of the LEAF-SUNNY device
WARNING:
Safety is guaranteed if these instructions are followed and therefore
they must be kept. Installation may require the involvement of qualified
personnel. Before proceeding with installation of the device ensure that
the environmental conditions are in compliance with and suitable for
the product characteristics. Before any operation on the device
disconnect mains power.
CONFIGURATION:
Instructions for installation and use contained in this manual are valid
for several configurations of the LEAF-SUNNY device, for which there
are differences. The LEDYE TLD (Touch-LED-Dimmer) model refers to the
configuration of the device that includes a dimmable electronic switch.
The LEAF-SUNNY IFR (PIR Sensor) model refers to the configuration of
the device that includes an electronic presence-detecting sensor. The
parts of the installation and use manual common to all models relate to
the LEAF-SUNNY model, or the configuration of the device that does
not incorporate a switch or sensor.
INSTALLATION LEAF-SUNNY TLD-IFR-SLAVE (fig. 1,2,3):
- Secure the lamp to the top using the screws (1) supplied.
- If necessary, drill a hole with a diameter of 8mm in the desired
position for the cable (2) to pass through.
INSTALLATION LEAF-SUNNY UP (fig. 4):
- Position and provisionally fix the lamp to the piece of furniture with
the screws (1), subsequently stopping the cable and the lamp with the
cable stop (3).
EN
INSTALLATION LEAF-SUNNY US:
- Choose suitable brackets (4) based on the thickness of the side panel.
This choice is facilitated by the inscriptions printed on the brackets
themselves, which also make it easier to identify the rh and lh bracket.
- Correct installation and fastening of the lamp are ensured when the
tolerance of the thickness of the side panels (+0/-0.5mm/ -1/64") is
respected.
- We suggest drilling 2.5 mm Ø (Ø3/32") holes in the cabinet
beforehand, if necessary drill a 8 mm diameter hole in the position you
want the cable to go through.
- Fasten the brackets (4) to the cabinet using the screws (5) in the
package (fig.5).
- Position the supports (4) as per the measurements shown in figure 6.
- Graft the lamp to the stirrups (4) up to when it will be stopped by the
hook on them, making the cable pass as shown in the detail "A".
- If you need to remove the lamp from the cabinet, insert a tool in the
side holes (6) on the heads, press on the hook and at the same time pull
the lamp towards you. This is to be done on both sides of the device
(fig.7 ).
INSTALLATION LEAF-SUNNY DR:
- Choose suitable brackets (4) based on the thickness of the side panel.
This choice is facilitated by the inscriptions printed on the brackets
themselves, which also make it easier to identify the rh and lh bracket.
- Correct installation and fastening of the lamp are ensured when the
tolerance of the thickness of the side panels (+0/-0.5mm/ -1/64") is
respected.
- We suggest drilling 2.5 mm Ø (Ø3/32") holes in the cabinet
beforehand, if necessary drill a 8 mm diameter hole in the position you
want the cable to go through.
- Fasten the brackets (4) to the cabinet using the screws (5) in the
package (fig.8).
