Deflating; Emergency Cpr Deflate; Cleaning Instructions - Bio Clinic OrthoDerm LAL Operación Manual

8
L O w A i r L O S S M At t r e S S r e p L A C e M e n t S y S t e M

.0 DeFLAtinG

Press Power button on Control Panel to
shift to Standby/CPR mode. LED will
illuminate to indicate power unit is in
Standby/CPR mode.
Power Switch to OFF position. Unplug
power cord from wall outlet. Disconnect
air hoses from side panel of power unit.
Begin rolling up mattress replacement
at head section forcing air out of system.
Continue this process until the majority
of air is removed from mattress replace-
ment and the mattress rolls up easily.
Connect the large strap buckles located
on the bottom side of the mattress re-
placement. Place deflated mattress re-
placement and power unit in optional
carry bag or plastic bag for transport and
storage.
.0 eMerGenCy Cpr
DeFLAte
In the event of an emergency, press the
Power button on the Control Panel to
shift the system to Standby/CPR mode.
LED will illuminate to indicate power
unit is in Standby/CPR mode. This will
deflate the mattress rapidly so CPR can
begin. To resume therapy, press Power
button On and re-set patient weight and
mode of operation as noted in Section
9.0 of this Manual ("Programming Set-
tings").
Press side panel
4.0 CLeAninG
inStruCtiOnS
routine Cleaning while in use By
Single patient:
Mattress replacement:
Routine cleaning of the air mattress can
be done at bedside by cleaning with mild
detergent or soap and water followed by
drying with a clean dry cloth. If the air
mattress cover becomes heavily soiled,
replace it with a Genuine Bio Clinic cov-
er or follow the Laundry/Decontamina-
tion instructions below. Soiled covers
should be disposed of following hospital
procedures or local environmental laws.
Always ensure air mattress and cover are
completely dry before allowing patient
back on surface.
power unit:
WARNING! Always unplug power
unit before cleaning. Power unit can be
cleaned by wiping down with damp cloth
using soap and water or mild neutral de-
tergent. Never spray cleaners or liquids
directly on power unit.
Laundry/Decontamination
Between patients:
Mattress replacement:
Air mattresses/covers must be thoroughly
cleaned between patients to avoid cross
contamination. The following instruc-
tions are a good guideline, but local infec-
tion control policies should be followed.
1. Don rubber gloves, eye protection,
and waterproof gown and mask if
necessary.
2. Turn power unit off and remove plug
from outlet to avoid electric shock.