Water And Drain Installation - Viking Range 5 Serie Guia De Instalacion

WATER & DRAIN INSTALLATION
The recommended water supply tubing is 1/4" OD copper. Stainless steel flex or reinforced PVC tube may also be used.
Install an easily accessible shut-off valve between the supply and the unit. This shut-off valve should not be installed behind
the unit.
Note: DO NOT use self-piercing type valves.
1. Remove the front service access panel by removing the screw.
2. Route the tubing through the right hole in the back to the inlet water
solenoid valve inlet.
3. Install a compression fitting on the tubing and connect to the inlet of the
solenoid (fitting is located in cloth bag behind access panel).
DRAINS
There are two types of ice machine models, one that drains by gravity and one
that has an internal drain pump.
Drain Pump Model drain installation
1. Locate the coil of 3/8" ID plastic drain tubing secured to the back of the unit.
2. Route the plastic drain tube from the back of the unit to the drain connection point.
IMPORTANT NOTE: Often an air gap is required by local codes between the ice maker drain tube and the drain receptacle.
Drain Tube,
Route to
building drain
Back View, Drain Pump Model
14
Screw
Service
Access
Panel
Water Inlet
Tube (field
supplied)