Crypto URC-605 Manual De Instrucciones página 21

Note:
• You can program up to 15 different key functions
• If in 30 seconds no key is been pressed then the red light will
turn off and the procedure is going to be canceled.
If you press the MACRO key while it is not programmed nothing will happen.
• Before using the MACRO programming make sure that the remote is
programmed to control all the devices you want to program by using the
MACRO function. To do this use the programming methods and the learning
function indicated in the above chapters of this guide.
Erase MACRO Programming:
Press the STB button and
indication light turn on constantly.
To erase MACRO1 button press code 9960 and then OK button.
5 DEVICE CODE REMINDER
Press the device button that you want once.
Press and hold
Release buttons and the device light will blink as many times according to the number.
If number is 0 then the light will blink fast 10 times.
For example let's say the device code is 1029
Press and button number 1: the device light will blink 1 time
Press and button number 2: the device light will blink fast 10 times
Press and button number 3: the device light will blink 2 times
Press and button number 4: the device light will blink 9 times.
at the same time until the device
button and press at the same time one of numbers 1,2,3,4.