Electrical Connection; Grounding Instructions; Fan Operation; Electrical Wiring - Procom Heating MG10TBF Manual De Operación

Do not use this heater if any
part of it has been under water.
Immediately call a qualified ser-
vice technician to inspect the
heater and replace any part of
the electrical system which has
been under water.

GROUNDING INSTRUCTIONS

This heater is for use on 120 volts. The cord
has a plug as shown at A in Figure 23. An
adapter as shown at C is available for con-
necting three-blade grounding-type plugs to
two-slot receptacles. The green grounding
lug extending from the adapter must be
connected to a permanent ground such as
a properly grounded outlet box. The adapter
should not be used if a three-slot grounded
receptacle is available.
Any electrical re-wiring of this appliance must
be done by a qualified electrician. This wiring
must be done in accordance with local codes
and/or in Canada with the current CSA C22.1
Canadian Electrical Code, and for US instal-
lations, the National Electrical Code ANSI/
NFPA NO 70.
WARNING: If repairing or
replacing any electrical compo-
nent or wiring, the original wire
routing, color coding and secur-
ing locations must be followed.
CAUTION: Label all wires
prior to disconnection when
servicing controls. Wiring errors
can cause improper and danger-
ous operation.
20

ELECTRICAL CONNECTION

FOR OPTIONAL BLOWER KIT

ELECTRICAL WIRING

www.usaprocom.com
Grounding Pin
C
Adapter
(Sold
Separately)
Grounding Means
Figure 23 - Grounded Electrical Outlet

FAN OPERATION

To operate the manual unit, turn ON/OFF
switch to the ON position. To operate the
Automatic unit, turn AUTO/O/MAN switch to
the desired position. MAN position will remain
constantly on. AUTO position will be controlled
by the sensor on the fan blower unit. The sen-
sor will be activated when the temperature of
the sensor head reaches the set point of the
switch after the heater is started. To stop the
operation, turn the switch to the O position.
WARNING: Never attempt to
service heater while it is plugged
in, operating, or hot. Burns and
electrical shock could result.
Only a qualified service person
should service or repair heater.
Verify proper operation after servicing. If any
of the original wire as supplied with the appli-
ance must be replaced, it must be replaced
with a wire of at least a 105º C temperature
rating.
Switch
Black
Green
White
A
Cover of
Grounded
B
Outlet Box
Metal Screw
Thermostat Switch
AUTO
O
MAN
Motor
200300-01A