Enlaces rápidos
a
b
i
h
NOTE: Hardware included for installation into drywall or plaster 1/2" to 5/8" thick. Other wall types
require additional hardware. See "Wall Types" section to determine hardware needs.
NOTA: Se incluyen herrajes de instalación para muro seco o yeso de 1,2 cm a 1,5 cm. Otros tipos de
paredes requieren herrajes de instalación adicionales. Vea la sección "Tipos de Paredes" para
determinar que tipo de herrajes necesita.
d
c
f
j
k
®
e
g
l
Up to 5' (1,52 m)
Closet Organizer
Installation Instructions
Organizador de Clóset
Instrucciones de Instalación
Tools and Materials
Herramientas y Materiales
1/4" (6 mm)
Philips Head
Before You Begin
1. Remove product from packaging and carefully inspect all parts.
(See Parts List below.)
2. Please read all instructions carefully before beginning.
Antes de Empezar
1. Saque el producto del paquete y cuidadosamente inspeccione
todas las partes. (Vea la lista de partes abajo).
2. Lea todas las instrucciones cuidadosamente antes de empezar.
Parts List
a. Wardrobe shelves—long (2) 02-4300
b. Wardrobe shelf—short (1) 02-4300
c. Support poles (2) 01-699
d. Shelf end caps (26) 01-603/604
e. Wall clips (13) 01-40991
f. Side wall brackets (3) 01-40984
g. Pole end caps (2) 01-244
h. 1/2" phillips head screws (6) 01-215
i. Pole clips (6) 01-40977
j. Pole connectors (1) 01-4307
k. 1" pins (13) 01-658
l. Pre-loaded Anchor (6) 01-50955
Lista de Partes
a. Repisas colgadoras—largas (2) 02-4300
b. Repisa colgadora—corta (1) 02-4300
c. Postes de soporte (2) 01-699
d. Tapones para repisa (26) 01-603/604
e. Fijadores de pared (13) 01-40991
f.
Soportes laterales (3) 01-40984
g. Tapones de poste (2) 01-244
h. Tornillos de cabeza phillips, 1,2 cm (6) 01-215
i.
Fijadores de poste (6) 01-40977
j.
Conectadores de poste (1) 01-4307
k. Clavijas de 2,5 cm (13) 01-658
n. Tarugos precargados (6) 01-50955
#2105
TM
Manuales relacionados para Emerson ClosetMaid 2105
Resumen de contenidos para Emerson ClosetMaid 2105
- Página 1 #2105 ® Up to 5' (1,52 m) Closet Organizer Installation Instructions Organizador de Clóset Instrucciones de Instalación Tools and Materials Herramientas y Materiales 1/4" (6 mm) Philips Head Before You Begin 1. Remove product from packaging and carefully inspect all parts. (See Parts List below.) 2.
- Página 2 Prepare Hardware 1. Determine top of each pole by locating hole closest to end. 2. Attach an endcap to top of one pole and bottom of other pole. Repeat for second set of poles. Bottom 3. Attach pole clips to each set of poles with 1/2" screws (provided) Parte Parte as shown.
- Página 3 Measure and Fit (cont.) NOTE: Diagram shows measurements for 5 foot closet. For cut 3" 7" 10" 10" shelves, determine length and reposition wall clips as necessary in even increments (in inches) to accommodate cut shelf size. Be 17,7 cm 25,4 cm 25,4 cm 7,62 cm...
- Página 4 Install Shelves 1. Firmly push all shelves into wall clips. Allow shelves to hang down from clips. 2. Locate side wall bracket. Gently lift shelf and "cup" side wall bracket over front lip of shelf and against wall (as shown). 3.