Bush Hog HDTH8 Manual De Seguridad Para El Personal De Operaciones Y Mantinimiento página 96

Tabla de contenido

FLEX LINK SETUP (continued)

Quick Hitch 3 Pt Lift (Figure 3-4)

For Quick Hitch pt. lift attachment to tractor the Flex Link is attached to the Mast in the lower

holes of the Mast Struts. Refer to Figure 3-4.

1. Before assembling the Flex Link to the Mast the Extension Spring should be installed to the

Pivot Bushing. It will be necessary to slightly pry the Spring open to allow the bushing to be

inserted into the loop. Move the spring so that it centered on the Pivot Bushing.

2. Place the Pivot Bushing between the Mast uprights and align Pivot Bushing with upper hole.

Install a 5/8" x 5-1/2" bolt through the Mast and Bushing and fasten using a 5/8" lockwasher

and 5/8" hex nut.

3. Place a Pivot Bushing through the rear holes of the Flex Link and install between the Mast

uprights. Tilt the Flex Link to allow the loop of the Spring to be inserted through the hole lo-

cated on the rear of the Flex Link. align the Bushing in the Flex Link with the holes in the

Mast and fasten using a 5/8" x 5-1/2" bolt , 5/8" lockwasher and 5/8" hex nut.

4. In the front hole in the Flex Link install a 3/4" x 4" bolt with the Top Link Bushing between the

Flex Link ears and fasten with a 3/4" lock nut.

Pivot Bushing

3-3/16" x 1-1/8"

Spring

Flex Link

Pivot Bushing

3-3/16" x 1-1/8"

Capítulos

Tabla de contenido