FRONT ROLLER KIT ASSEMBLY (OPTIONAL) (Figure 3-8)
1. Attach the Roller Mounting Brackets to the front of the deck using two 3/8" x 1" carriage bolts, , 3/8" lockwashers
and 3/8" hex nuts in the front mounting holes and two 3/8" x 1-1/4" carriage bolts, 3/8" lockwashers and 3/8"
hex nuts in the rear mounting holes as shown in figure (Figure 3-8) below.
2. Place the sleeve in the roller and a 3/4" flatwasher on each end.
3, Place the roller and sleeve assembly between the mounting brackets. Align the holes and insert the stud
through the mounting brackets and the roller assembly.
4. Attach a 1/2" locknut to each end of the stud and tighten.
Figure 3-8
1/2" Locknut
each end
Sleeve
3/4" Flatwasher
HDTH 8 Finish Mower 06/19
© 2019 Alamo Group Inc.
ASSEMBLY
Stud
R.H. Roller
Bracket
Roller
3/4" Flatwasher
Assembly Section 3-10
L.H. Roller
Bracket
Front Holes
3/8" x 1" Bolts
3/8" Lockwashers
3/8" Hex Nuts
Rear Holes
3/8" x 1-1/4" Bolts
3/8" Lockwashers
3/8" Hex Nuts