Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Leg with Hole
Bolt Holes
Suppo_Tabs
Choose a good, cleared assembly area and
get a friend to help you put your smoker
together. Lay cardboard down to protect
smoker finish and assembly area.
CAUTION:
Some parts may contain
sharp edges. Wear protective
gloves if necessary.
Note: With the help of a friend, turn the
smoker cabinet upside down.
Step 1
For each leg, line up the holes of cabinet
and insert the 1/4-20 X 5/8" bolts; nuts are
pre-welded to the cabinet. Securely tighten
the bolts. Make note of the arrow in the
illustration. This is where the leg with the
hole in it should be installed. DO NOT yet
insert the two bolts in the locations indicated
by the circles.
Step 2
Place the Control Panel Assembly between
the front legs as shown. There is a slot on
each side of the control panel that fits
around the edge of the leg. The two
mounting tabs fit to the inside of the legs
and line up with the bolt holes. Be sure both
the support tabs on the back side of the
control panel are captured behind the legs
as shown to the right.
Step 3
Insert the two remaining 1/4-20 X 5/8" bolts
through the mounting tabs and tighten them
securely.
Tabla de contenido
