Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ADDING WOOD / CHARCOAL
To add wood chips before cooking, simply fill the wood chip
box with your choice of flavoring
hardwood chips. The
amount and type of wood you use is entirely up to you. One
full box is typically enough for several hours of smoking.
Once the box is filled, place the lid on top of the box and
set the box in the smoker.
To add wood chips while cooking, we recommend
using
tongs or long handled pliers to remove the box lid and to
place the pieces into the wood chip box without removing
the box. It is not recommended to remove the wood chip
box while the smoker is in operation.
CAUTION: The wood chip box and lid get very hot.
Avoid handling them while in use. Always
wear protective oven mitts when handling
hot components.
Cooking Tip - Flavoring wood:
• Small wood chips work best inside the wood chip box.
• Use dry hardwoods such as hickory, pecan, apple,
cherry, or mesquite.
• Most fruit or nut tree woods produce excellent smoke
flavoring.
• Do not use resinous woods such as pine or plywood.
These usually produce unpleasant flavoring.
• Let your taste be your guide - experiment with different
types and quantities of wood chunks, chips, or sticks.
You can even mix woods.
To produce more smoke and to prevent fast burning, pre-
soak the wood chips in a separate bowl of water for at
least 20 minutes, or wrap the chips in perforated
aluminum foil.
Most smoke flavoring
occurs within the first hour of
cooking. Adding wood chips after the first hour is
typically not necessary unless extra smoke flavoring
is
desired.
IGNITER LIGHTING SYSTEM:
1,
2,
3.
4,
5.
6.
7,
8,
Check all connections
for leaks using the "soapy
water"
test as explained on page 13.
Open the smoker cabinet door.
Check for any blockage to the burner. Remove any
foreign
objects or matter.
Be sure the burner control knob is in the "OFF" position.
Open the LP cylinder valve by turning counter-clockwise.
To light unit with the igniter, push in and turn the burner
control knob counter-clockwise
to the high setting.
Immediately
rotate the igniter repeatedly to click it
several times (you should see a small spark jumping
from the end of the electrode rod to the side of the
burner). If the burner doesn't light within 3 to 5 seconds,
turn the burner control knob off and wait five minutes for
gas to clear before repeating the steps again. If burner
still fails to light try match lighting the smoker using the
instructions noted below.
Once the burner is lit, then close the door to allow heat
to accumulate.
MATCH LIGHTING:
1. Repeat steps 1 thru 5 of the Igniter Lighting System
above.
2,
Remove the Wood Chip Box and its stand from inside
the smoker. Light a paper match and drop it into the
burn chamber, making sure it falls next to the brass
burner. Quickly turn the control knob to the light
position. If the burner does not light within 4 or 5
seconds, turn the control knob off, wait 5 minutes for
gas to clear, and repeat the process.
t5
Tabla de contenido
