Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3
1
TIMER
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1
2
3
4
Press one of the function
buttons
to select
a
source.
If TUNER/BAND is pressed, the band cannot be selected in
this step.
Press TIMER repeatedly
until @ appears on the
display.
Time and audio source name flash alternatively.
a
Within 6 seconds, turn MULTI JOG to designate
the timer-on time, then press ENTER or II.
Turning MULTI JOG changes both the hour and the minute.
+
or >
is also. available instead of MULTI JOG. Holding
these buttons down will vary the time rapidly.
Within 4 seconds, turn MULTI JOG to select the
dluration for the timer-activated
period.
The duration can be set between 5 and 240 minutes in
5-
minute steps.
+
or E+ is also available instead of MULTI JOG.
5
6
7
Adjust the volume.
5
The source sound will play at the volume level set in this step
i
,
when the power is turned on by the timer.
f
./""..
,~,< , -&
If the volume level is set to 21 or higher, however, it will
'"~"'~
automatically be set to 20 when the power is turned on.
!I
:L!!J " ~ $ggl
,,. =! .+
Prepare the source.
$&?
8
,,. ,
To listen to a CD, load the disc to be played first on tray 1.
'~-"
To listen to a tape, insert the tape into deck 1 or 2.
d
To listen to the radio, tune in to a station.
Press POWER .to turn off the power.
When the timer-on time is reached; the unit turns on and
begins play with the selected source.
m
You can change the source that was selected in step 1 by
pressing one of the function buttons before pressing ENTER or
II in step 3.
To check the timer setting
Press TIMER.
The selected source, the timer-on time, and the duration for the
timer-activated period will be displayed for 6 seconds.
To change any of the previous setting
Carry out from step 1.
However, if you do not change the timer-on time, in step 3 just
press ENTER twice and continue from step 4.
To cancel timer standby mode temporarily
Press TIMER repeatedly so that @ disappears.
To restore the timer standby mode, press again to display ~.
Using the unit while the timer is set
You can use the unit normallv after settinq the timer.
Before turning off the power, "carry out st;p 5 and 6.
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
Timer recording is applicable for TUNER and VI DEO/AUX (with
an external timer) sources only.
Press either TUNER/BAND or VIDEO/AUX to select a source,
then press TIMER repeatedly
until 0 REC appears on the
display.
Within 6 seconds, carry out the steps of "SETTING THE TIMER
from step 3 and inserf the tape to be recorded into deck 2 after
step 6.
m
When the power-economizing
mode (page 6) has been turned
on, the timer recording volume level will be O (minimum level).
You cannot use the timer function to record from a CD, tape or
MD.
The duration will be automatically set after 4 seconds. It will
also be set if ENTER or II is pressed within 4 seconds after
step 4.
ENGLISH
26
Tabla de contenido
