Replacing The Blades; How To Charge - Sima CX-16 Manual De Instrucciones

CAUTION
●Do not touch the switch when you went to
rotate the machine body.
Blades may move and it causes damage.

4. Replacing the blades

CAUTION
●Take the battery pack out before work.
●Pay your careful attentions as the blades edges are so sharp.
●Install the blades in correct direction
(1) Take out the hexagon bolt by #4 hexagon wrench.
(2) Fix the blades as below in correct direction. Loose fixing may cause
unexpected accident.

HOW TO CHARGE:

CAUTION
●Check the plug and cord before use, if there are some damage, do not use it
and ask our distributor to repair it to avoid accident.
●New battery is not always charged full, so charge it full before use.
1. Putting the charger plug into outlet.
Charge lamp goes on and off when you put the plug into the outlet.
NOTE
If the plug does not fit the outlet and cannot be firm, or easy to put off, bring
and consult with shop or out agent for repair. Unproper use may cause the fire.
2. Fixing the battery pack to charger.
When you fix the battery pack to charger, it starts to charge and charger lamp
goes on and off. Fix the battery pack to the bottom of charger firmly on the
correct direction.
NOTE
It the charger lamp does not turn on, pull out the charger plug from outlet and
check if the battery will be fixed into the charger firmly again.
3.Charging
(1). When put, the charger plug into the outlet, the green light on charger will
light up.
(2). After putting the battery into charger to charge, the green lights will be
blinking.
(3). When the battery is charged fully, the green light will stop to blink and keep
7