Spraying Process; Maintenance And Cleaning - Parkside PFSP 100 Instrucciones De Utilización Y De Seguridad

Spraying process

Q
1. You can vary the spray by adjusting the regulator
button (see Fig. D). The spray is correctly
2
set when no drops are formed and the gun
produces a fine, consistent spray pattern.
2. Do not switch the device on or off while it is
over the surface to be sprayed. Instead, start
and stop the spraying process approximately
10 cm outside the surface to be sprayed.
notE: The distance between the nozzle and
the workpiece depends on the material being
sprayed (approx. 20 to 35 cm spraying dis-
tance, depending on the spray cone and the
desired amount of material to be applied).
j
Carry out a trial in each case to determine the
most effective spraying distance.
j
Start with a longer distance.
3. Spray corners or small decorative details first
using short bursts of spray.
Then go on to the actual spraying process.
4. The spray process should follow the sequence
shown in Fig. E – keep the spray gun moving
parallel to the surface
– Do not incline the spray gun
– Move the spray gun at a constant speed
– Apply the sprayed medium as thinly as possible
– The layer(s) of sprayed medium need(s) to
be allowed to dry for some time before you
apply the next coat Fig. F) at right angles to
the previous coat.
5. Do not allow the paint cup
pletely while spraying – drops may form!

Maintenance and cleaning

Q
General advice:
WArnInG!
1.
fore you carry out any tasks on the spray gun.
Do the same when you take a break from spraying.
2. After each use, spray thinners (in the open
air only – danger of explosion!) or
water through the device.
3. To protect from rust after cleaning, you can
spray sewing machine oil through the device.
4. WArnInG!
in the cleaning medium.
Bringing into use / Maintenance and cleaning / Disposal
to empty com-
7
Pull out the mains plug be-
Never immerse the device
5. Never use inflammable solvents to clean the
device.
6. Use a dry cloth to clean the housing. Never
use petrol, solvents or cleaning agents that
might attack plastic.
Cleaning instructions:
1. Unscrew the attachment screw
2. Take off the pump housing
3. Unscrew nozzle
8
pressure valve .
9
4. Take the pump piston
the pump housing
10
5. Clean parts ,
4 5
6. Fit the components back in reverse order.
tIP: After use or cleaning, hang up the electrical
power tool from the metal stirrup
Disposal
Q
The packaging is wholly composed of
environmentally-friendly materials that can
be disposed of at a local recycling centre.
Do not dispose of electrical
power tools with the household
rubbish!
In accordance with European Directive
2002 / 96 / EC (covering waste electrical and elec-
tronic equipment) and its transposition into national
legislation, worn out electrical power tools must be
collected separately and taken for environmentally
compatible recycling.
Contact your local refuse disposal authority for
more details of how to dispose of your worn out
electrical devices.
Environmental compatibility and
disposal of materials:
j
Paint, varnishes etc. are special wastes which
must be disposed of in the appropriate manner.
j
observe the regulations applicable in your area.
j
observe the manufacturer's instructions.
, see Fig. A.
1
downwards.
10
and remove the suction-
and spring out of
4 5
.
, , with thinners.
8 9
.
14
GB/MT 31