Shindaiwa SP41BPS Manual De Uso Y Cuidado página 4

SPRAYER COMPONENTS & USE INFORMATION, Continued
WAND ASSEMBLY
1. Make sure the o-ring is installed on the end of the wand. Insert the wand into shut-off valve.
2. Turn and tighten the retaining nut clock-wise onto the shut-off valve.
Retaining Nut
INSTALLING THE PUMP HANDLE
The pump handle can be mounted on either side of the pump shaft
(A). To install the pump handle place the handle (C) over the shaft
(A) aligning the pump handle holes and shaft holes. Slide the bolts
(B) through the aligned holes as shown in figure 1 thru 4. Tighten
nuts (D) to bolts. There are holes in the pump handle to allow for
either right (fig.5) or left (fig.6) hand mounting.
Nylon Lock Nut
Threaded Bolt
Figure 1
Figure 4
Tighten nut to bolt
Pump Handle
Positioned For Use
(right hand shown)
O-ring
Wand
Figure 2
Line up holes
Figure 5
Right Hand
Figure 3
Slide bolt through holes
Figure 6
Left Hand
3E
Shut-off
Valve
A. Pump Shaft
D. Nuts
B. Bolts
C. Pump Handle