System Status Indicators - SeQual Eclipse 3 Manual Del Usuario

buzzer: An audible alarm (or buzzer) is used to alert you to the operating condition of
the device, either a warning or failure, and to confirm a valid key press by the user.
11
Personal Ambulatory Oxygen System Users Manual
Increase or Decrease Flow Setting buttons:
Use these buttons to set the flow to your prescribed setting.
Delivery mode button and Indicator:
Continuous Flow and Pulse Dose Mode. The Pulse Dose Mode activates
autoSAT Technology—as your breath rate changes, the Eclipse servo-
controls the unit to provide a consistent bolus size. The Pulse Dose Mode
allows a significant increase in the operating time while powered by
the battery. When this mode is activated, the green Pulse Dose Mode
Indicator illuminates and a pulse of oxygen is delivered with each
inspiratory effort.
AlERT (yellow) Indicator—low and medium priority Alerts:
When illuminated, this indicates a low priority awareness condition or
Caution. Continue to use your system and refer to the Troubleshooting
Table for the proper response. A flashing yellow indicates a medium
priority alert. A prompt response is necessary.
AlARm (Red) Indicator —high priority Alarms:
ity alarm condition. An immediate response is necessary. Refer to the
Troubleshooting Table and contact your home care provider.
Flow Setting Indicator:
Your home care provider will correctly set your prescribed flow for
the Continuous Flow Mode (LPM) and/or your Pulse Dose Mode (mL)
settings. Each time you power the device ON, the previous mode and/or
setting has been saved and will be used at start-up.
power Cartridge (battery) Status Gauge:
charge remaining in the battery. Each of the five horizontal gray bars
represents approximately 20% of the total battery charge. When
the battery is being charged, the charge indicator bars will blink in a
waterfall-type fashion.
If the battery is not installed, or if it is improperly installed, the Power
Cartridge (battery) Status Gauge will not be illuminated.
External power Indicator:
is using the AC or DC Power Supply, this indicator will appear on the
User Control Panel.
The button toggles between
This is the main focus on your control panel.
This indicator displays the
When the Eclipse is properly plugged in and
Indicates a high prior-